u-boot
Hi Friends,
I am 1st time user of u-boot.
I am to bring up arm-based board. i.e my target board is going to be based on ARM architecture/
I follwed the following steps.
1,I installed precompiled tool chain on my machine 2,Built / compile linux kernel.
3,IBuilt / compile u-boot.
Now what should be the next step?
Is there any document availble to tell me the exact procedure for this.
I am on linux -redhat -enterprise machine. kernel version 2.6
I would appreciate your rely.
Regards
Harsh
Dear Harshad,
Quoted 10 lines · Harshad Poshtiwala
I am 1st time user of u-boot.
I am to bring up arm-based board. i.e my target board is going to be based on ARM architecture/I follwed the following steps.
1,I installed precompiled tool chain on my machine 2,Built / compile linux kernel.
3,IBuilt / compile u-boot.Now what should be the next step?
Run U-Boot and then run Linux.
Quoted 1 line
Is there any document availble to tell me the exact procedure for this.
Sure, the U-Boot sources contain a very nice README, and for more Information you can take a look at the DULG:
http://www.denx.de/wiki/DULG/WebHome
Regards
Markus Klotzbuecher