EDD still failing on some systems with 2.6.23-rc6-git2
I added debugging code to print a letter for each step in i386 setup, and it gets to 'J', then it hangs:
/* Query EDD information */
#if defined(CONFIG_EDD) || defined(CONFIG_EDD_MODULE)
putchar('J');
query_edd();#endif
Multiple reports of this happening on 2.6.23-rc6 can be found at the end of:
https://bugzilla.redhat.com/show_bug.cgi?id=251724
https://bugzilla.redhat.com/show_bug.cgi?id=239585
Quoted 7 lines · Chuck Ebbert
I added debugging code to print a letter for each step in i386 setup, and it gets to 'J', then it hangs:
/* Query EDD information */ #if defined(CONFIG_EDD) || defined(CONFIG_EDD_MODULE) putchar('J'); query_edd();
Quoted 7 lines
#endif
Multiple reports of this happening on 2.6.23-rc6 can be found at the end of:
https://bugzilla.redhat.com/show_bug.cgi?id=251724
https://bugzilla.redhat.com/show_bug.cgi?id=239585
I just attached a test patch to the bug report shown above. If someone with access to the relevant hardware could test out the patch, I would greatly appreciate it.
-hpa
Quoted 13 lines · H. Peter Anvin
Quoted 12 lines · Chuck Ebbert
I added debugging code to print a letter for each step in i386 setup, and it gets to 'J', then it hangs:
/* Query EDD information */ #if defined(CONFIG_EDD) || defined(CONFIG_EDD_MODULE) putchar('J'); query_edd();#endif
Multiple reports of this happening on 2.6.23-rc6 can be found at the end of:
Quoted 7 lines
Quoted 2 lines
https://bugzilla.redhat.com/show_bug.cgi?id=251724
https://bugzilla.redhat.com/show_bug.cgi?id=239585I just attached a test patch to the bug report shown above. If someone with access to the relevant hardware could test out the patch, I would greatly appreciate it.
Still fails. And apparently fails on disk 0, because it hangs right after printing a zero:
arch/i386/boot/edd.c +1 -0
@@ -151,6 +151,7 @@ void query_edd(void)* Scan the BIOS-supported hard disks and query EDD * information... */ +putchar ('0' + (devno -0x80 ) %10 );get_edd_info (devno, &ei);if (boot_params.eddbuf_entries <EDDMAXNR ) {
Quoted 7 lines · Chuck Ebbert
Still fails. And apparently fails on disk 0, because it hangs right after printing a zero:
arch/i386/boot/edd.c void query_edd(void) · line 157
Quoted 7 lines
arch/i386/boot/edd.c +1
-0@@ -151,6 +151,7 @@ void query_edd(void)* Scan the BIOS-supported hard disks and query EDD * information... */ +putchar ('0' + (devno -0x80 ) %10 );get_edd_info (devno, &ei);if (boot_params.eddbuf_entries <EDDMAXNR ) {
You know... we actually do have printf()... you don't have to play this kind of games; you can just printf("Drive %x...\n", devno);
So does this happen ONLY when booting from CD-ROM, or is there any other case when it fails, too?
-hpa