device tree in open firmware on power6
Hi,
When I set linux 2.6.26-rc1 as default kernel to boot in /etc/yaboot.conf, then the device tree in open firmware shows only one memory node ( the same memory node appears in /proc/device-tree/memory@0 ). But when RHEL5.2 kernel is set as default in /etc/yaboot.conf then the device tree in open firmware shows plenty of memory nodes. Following is the open firmware output..
linux-2.6.26-rc1:
<snip>
0 > dev / ls
...000000caf1b8: /PowerPC,POWER6@6000000cb0120: /memory@0000000cb83d8: /ibm,dynamic-reconfiguration-memory000000cbcd60: /options
...
0 > dev /memory@0 ok
0 > .properties
name memory device_type memory reg 00000000 00000000 00000000 08000000 available 00000000 00004000 00000000 00bfc000 00000000 02020000 00000000 05fe0000 #address-cells 00000001 #size-cells 00000000 ibm,phandle fffffffa ibm,associativity 00000004 00000000 00000000 00000000 00000000
<snip-end>
when default=RHEL5.2:
0 > dev / ls 000000c8d200: /ibm,serial000000c8dff8: /chosen
...000000cae2c0: /PowerPC,POWER6@4000000caf1b8: /PowerPC,POWER6@6000000cb0120: /memory@0000000cb5af0: /memory@8000000000000cb5ce0: /memory@c000000000000cb5ed0: /memory@10000000000000cb60c0: /memory@14000000000000cb62b0: /memory@18000000000000cb64a0: /memory@1c000000000000cb6690: /memory@20000000
...
The open firmware environment variable "ibm,fw-new-mem-def" is false for rhel5.2 kernel where as it is 'true' for 2.6.26-rc1 as default kernel to boot. Any inputs if the one memory node in 2.6.26-rc1 should show the size of available system memory ?, or there should be many memory nodes for 2.6.26-rc1 ?.
Thanks,
Chandru
Quoted 6 lines · Chandru
When I set linux 2.6.26-rc1 as default kernel to boot in
/etc/yaboot.conf, then the device tree in open firmware shows only one memory node ( the same memory node appears in/proc/device-tree/memory@0). But when RHEL5.2 kernel is set as default in/etc/yaboot.confthen the device tree in open firmware shows plenty of memory nodes. Following is the open firmware output..
Current kernels tell the firmware that they can handle having memory represented in the /ibm,dynamic-reconfiguration-memory node, which is a more compact representation than having it represented in multiple /memory@xxx nodes. Therefore firmware reports most of the memory in the /ibm,dynamic-reconfiguration-memory node you have here:
Quoted 8 lines
linux-2.6.26-rc1:
<snip>
0 > dev / ls
...000000caf1b8: /PowerPC,POWER6@6000000cb0120: /memory@0000000cb83d8: /ibm,dynamic-reconfiguration-memory
and only gives you one /memory@xxx node, which represents the real memory area. See sections C.6.2.3 and C.6.6.2 of PAPR for more information.
Paul.