Skip to contentSkip to conversation

mgcoge, mgsuvd: add DTT (LM75) support.

PATCH New Heiko Schocher 1 participant 1 message Oct 15, 2008

lore
Share & tools
lore

Heiko Schocher

author
#0 lore raw

PATCH v2 10/16 mgcoge, mgsuvd: add DTT (LM75) support.

Signed-off-by Heiko Schocher <[email protected]>
---
 include/configs/mgcoge.h |    9 +++++++++
 include/configs/mgsuvd.h |    9 +++++++++
 2 files changed, 18 insertions(+), 0 deletions(-)
include/configs/mgcoge.h +9 -0
index 8cff642..bfbbd45 100644
@@ -81,6 +81,7 @@
  */
 #include <config_cmd_default.h>
 
+#define CONFIG_CMD_DTT
 #define CONFIG_CMD_ECHO
 #define CONFIG_CMD_EEPROM
 #define CONFIG_CMD_I2C

@@ -209,6 +210,14 @@
 #define CFG_EEPROM_PAGE_WRITE_BITS 3
 #define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10
 
+/* I2C SYSMON (LM75, AD7414 is almost compatible)			*/
+#define CONFIG_DTT_LM75		1	/* ON Semi's LM75		*/
+#define CONFIG_DTT_SENSORS	{0}	/* Sensor addresses		*/
+#define CFG_DTT_MAX_TEMP	70
+#define CFG_DTT_LOW_TEMP	-30
+#define CFG_DTT_HYSTERESIS	3
+#define CFG_DTT_BUS_NUM		(CFG_MAX_I2C_BUS)
+
 #define CFG_IMMR		0xF0000000
 
 #define CFG_INIT_RAM_ADDR	CFG_IMMR
include/configs/mgsuvd.h +9 -0
index 85c6ac9..c569c81 100644
@@ -113,6 +113,7 @@
 
 #define CONFIG_CMD_ASKENV
 #define CONFIG_CMD_DHCP
+#define CONFIG_CMD_DTT
 #define CONFIG_CMD_EEPROM
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_NFS

@@ -380,4 +381,12 @@
 #define CFG_EEPROM_PAGE_WRITE_BITS 3
 #define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10
 
+/* I2C SYSMON (LM75, AD7414 is almost compatible)			*/
+#define CONFIG_DTT_LM75		1	/* ON Semi's LM75		*/
+#define CONFIG_DTT_SENSORS	{0, 2, 4, 6}	/* Sensor addresses		*/
+#define CFG_DTT_MAX_TEMP	70
+#define CFG_DTT_LOW_TEMP	-30
+#define CFG_DTT_HYSTERESIS	3
+#define CFG_DTT_BUS_NUM		(CFG_MAX_I2C_BUS)
+
 #endif	/* __CONFIG_H */
Signature · 5 lines
1.5.6.1

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany