Interrupts in uboot with ARM AT91SAM9 (V2)
Hello,
I?ve already inserted the following code:
In at91sam9g20ek.c:
void thread_test(void)
{
printf("RESET via INT\n");
}
in function :static void at91sam9g20ek_macb_hw_init (void) {
.......
at91_sys_write(AT91_RSTC_MR, AT91_RSTC_KEY | AT91_RSTC_URSTIEN); // Reset Bit AT91_RSTC_URSTS at91_sys_read(AT91_RSTC_SR);
at91_sys_write(AT91_PMC_PCER, 1 << AT91_ID_SYS); at91_sys_write(AT91_AIC_IDCR, 0x01 << AT91_ID_SYS); at91_sys_write(AT91_AIC_SVR(AT91_ID_SYS), (unsigned int)thread_test); at91_sys_write(AT91_AIC_SMR(AT91_ID_SYS), 5 | AT91_AIC_SRCTYPE_LOW); at91_sys_write(AT91_AIC_ICCR, 0x01 << AT91_ID_SYS); at91_sys_write(AT91_AIC_IECR, 0x01 << AT91_ID_SYS);
.....
}
if I trigger my interrupt - the system hangs....nothing is printed on
screen and I can?t enter anything in the prompt ?
Anything else that I have to add ???
Thanks very much...
Manuel
Quoted 1 line
Quoted 1 line
Quoted 1 line
Jean-Christophe PLAGNIOL-VILLARD <[email protected]> 05.09.2009
02:49 >>>
Quoted 5 lines · Manuel Sahm
Hello,
I have to use interrupts in UBoot 1.3.4 - how could I enable them ?
I have an AT91SAM9G20 - in ist header file I enable
CONFIG_USE_IRQ
und
Quoted 7 lines
uncomment the lines#ifdefc
CONFIG_USE_IRQ#error .... #endif. I inserted the lines:
#defineCONFIG_STACKSIZE_IRQ(4*1024)
#defineCONFIG_STACKSIZE_FIQ(4*1024)In the file (/lib_amr/interrupts.c) I have to insert a function
called
Quoted 11 lines
do_irq().
I inserted:void
do_irq(struct pt_regs* pt_regs)
{
printf("interrupt request\n");
show_regs(pt_regs);
bad_mode();
}When UBOOT starts all seems to be OK, but if I trigger my interrupt
-
Quoted 4 lines
the system hangs....nothing is printed on screen anmd I can?t enter anything in the prompt ?
Could you please help me.... ?
you need to clear the interrupt and add the at91 interrupt controller to use it
Best Regards,
J.
_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot