ARM: OMAP3: Add support for the IGEP v2 board (rev B)
Hello,
For what I've seen on the Internet concerning your card, there is only one MMC card reader. Besides, there is the following piece of code :
Quoted 5 lines
(quoted diff) +5
-0+static struct twl4030_hsmmc_info mmc[] = { + { + .mmc = 1, + .wires = 4, + .gpio_cd = -EINVAL,
Review
Quoted 10 lines
(quoted diff) +10
-0+ .gpio_wp = -EINVAL, + }, + { + .mmc = 2, + .wires = 4, + .gpio_cd = -EINVAL, + .gpio_wp = -EINVAL, + }, + {} /* Terminator */ +};
Maybe I am mistaken, but doesn't that mean there are two MMC cards ?
I am interested in the subject, as I am trying to write my own board file for our custom, beagleboard-based card, with no success so far concerning the second MMC reader...
Best regards,
Fred
Quoted 23 lines · Frédéric BEGOU
Hello,
For what I've seen on the Internet concerning your card, there is only one MMC card reader. Besides, there is the following piece of code :
Quoted 5 lines
(quoted diff) +5
-0+static struct twl4030_hsmmc_info mmc[] = { + { + .mmc = 1, + .wires = 4, + .gpio_cd = -EINVAL,Review
Quoted 10 lines
(quoted diff) +10
-0+ .gpio_wp = -EINVAL, + }, + { + .mmc = 2, + .wires = 4, + .gpio_cd = -EINVAL, + .gpio_wp = -EINVAL, + }, + {} /* Terminator */ +};Maybe I am mistaken, but doesn't that mean there are two MMC cards ?
Quoted 1 line
I am interested in the subject, as I am trying to write my own board file for our custom, beagleboard-based card, with no success so far concerning the second MMC reader...
Well, it seems that the board is question has a WIFI module connected to the second mmc. What is your problem right now ? Remember that all three MMC slots are different in what kind of voltage they can drive.
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html