Skip to contentSkip to conversation

NAND on eLBC

U-Boot Andre Schwarz 2 participants 3 messages Nov 5, 2010 – Nov 10, 2010

lore
Share & tools
lore
#0 lore raw

Scott,

looks like I made a mistake on current MPC8377 NAND wiring.

Nand-Flash "write enable" is wired to LFWE1 ... I connected each WE to its corresponding CS, i.e. :

- CS0/WE0 -> Nor Flash
- CS1/WE1 -> Nand Flash
- CS2/WE2 -> MRAM

Am I assuming right that FCM can only use WE0 ?

Do you see any issue with connecting all devices to WE0 since they have distinct chip selects ?

Regards,
Andr?

MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner

#1 lore raw
Quoted 4 lines · On Fri, 5 Nov 2010 10:21:53 +0100 Andre Schwarz…

Scott,

looks like I made a mistake on current MPC8377 NAND wiring.

Quoted 8 lines

Nand-Flash "write enable" is wired to LFWE1 ... I connected each WE to its corresponding CS, i.e. :

- CS0/WE0 -> Nor Flash
- CS1/WE1 -> Nand Flash
- CS2/WE2 -> MRAM

Am I assuming right that FCM can only use WE0 ?

I think so. It looks like the other lines were meant to be byte selects for NOR/UPM, not anything to do with the chip select.

Quoted 2 lines

Do you see any issue with connecting all devices to WE0 since they have distinct chip selects ?

I guess not, especially if that's the only way the FCM works.

But to be sure, maybe ask official Freescale support channels, and/or someone who's more familiar with the hardware side of this stuff.

-Scott

#2 lore raw

Scott,

Quoted 5 lines
Quoted 5 lines

looks like I made a mistake on current MPC8377 NAND wiring.

Nand-Flash "write enable" is wired to LFWE1 ... I connected each WE to its corresponding CS, i.e. :

Quoted 9 lines
Quoted 6 lines
- CS0/WE0 ->  Nor Flash
- CS1/WE1 ->  Nand Flash
- CS2/WE2 ->  MRAM

Am I assuming right that FCM can only use WE0 ?

I think so. It looks like the other lines were meant to be byte selects for NOR/UPM, not anything to do with the chip select.

ok - understood.

Quoted 5 lines
Quoted 3 lines

Do you see any issue with connecting all devices to WE0 since they have distinct chip selects ?

I guess not, especially if that's the only way the FCM works.

After some rework (LFWE1->LFWE0) the NAND Flash is now working fine.

Regards,
Andr?

MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner