NAND on eLBC
Scott,
looks like I made a mistake on current MPC8377 NAND wiring.
Nand-Flash "write enable" is wired to LFWE1 ... I connected each WE to its corresponding CS, i.e. :
- CS0/WE0 -> Nor Flash
- CS1/WE1 -> Nand Flash
- CS2/WE2 -> MRAM
Am I assuming right that FCM can only use WE0 ?
Do you see any issue with connecting all devices to WE0 since they have distinct chip selects ?
Regards,
Andr?
MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner
Quoted 4 lines · On Fri, 5 Nov 2010 10:21:53 +0100 Andre Schwarz…
Scott,
looks like I made a mistake on current MPC8377 NAND wiring.
Quoted 8 lines
Nand-Flash "write enable" is wired to LFWE1 ... I connected each WE to its corresponding CS, i.e. :
- CS0/WE0 -> Nor Flash
- CS1/WE1 -> Nand Flash
- CS2/WE2 -> MRAMAm I assuming right that FCM can only use WE0 ?
I think so. It looks like the other lines were meant to be byte selects for NOR/UPM, not anything to do with the chip select.
Quoted 2 lines
Do you see any issue with connecting all devices to WE0 since they have distinct chip selects ?
I guess not, especially if that's the only way the FCM works.
But to be sure, maybe ask official Freescale support channels, and/or someone who's more familiar with the hardware side of this stuff.
-Scott
Scott,
Quoted 5 lines
Quoted 5 lines
looks like I made a mistake on current MPC8377 NAND wiring.
Nand-Flash "write enable" is wired to LFWE1 ... I connected each WE to its corresponding CS, i.e. :
Quoted 9 lines
Quoted 6 lines
- CS0/WE0 -> Nor Flash - CS1/WE1 -> Nand Flash - CS2/WE2 -> MRAMAm I assuming right that FCM can only use WE0 ?
I think so. It looks like the other lines were meant to be byte selects for NOR/UPM, not anything to do with the chip select.
ok - understood.
Quoted 5 lines
Quoted 3 lines
Do you see any issue with connecting all devices to WE0 since they have distinct chip selects ?
I guess not, especially if that's the only way the FCM works.
After some rework (LFWE1->LFWE0) the NAND Flash is now working fine.
Regards,
Andr?
MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner