ARM STM/i.MX: Add possibility to choose the bit per pixel for STM video driver
Subsystems (4)
PATCH 2/4 ARM STM/i.MX: Add possibility to choose the bit per pixel for STM video driver
When describing an new video interface, it is now possible to select the bit per pixel. If nothing is chosen 16bpp is selected by default.
Signed-off-by Gregory CLEMENT <[email protected]>
--- arch/arm/mach-stm/include/mach/fb.h | 1 + drivers/video/stm.c | 5 ++++- 2 files changed, 5 insertions(+), 1 deletions(-)
arch/arm/mach-stm/include/mach/fb.h +1 -0
@@ -37,6 +37,7 @@ struct imx_fb_videomode {unsigned dotclk_delay;/**< refer manual HW_LCDIF_VDCTRL4 register */ unsigned ld_intf_width;/**< refer STMLCDIF_* macros */ + u32 bits_per_pixel; };#endif /* __MACH_FB_H */
drivers/video/stm.c +4 -1
@@ -496,7 +496,10 @@ static int stmfb_probe(struct device_d *hw_dev) fbi.info.mode = &fbi.info.mode_list[0 ]; fbi.info.xres = fbi.info.mode->xres; fbi.info.yres = fbi.info.mode->yres; - fbi.info.bits_per_pixel =16 ; +if (pdata->bits_per_pixel) + fbi.info.bits_per_pixel = pdata->bits_per_pixel; +else + fbi.info.bits_per_pixel =16 ; size =calc_line_length (fbi.info.mode->xres, fbi.info.bits_per_pixel) * fbi.info.mode->yres;
Signature · 9 lines
1.7.0.4 _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox