Skip to contentSkip to conversation

Can't build for BeagleBoard

DISCUSSION Gary Thomas 2 participants 2 messages Feb 10, 2011 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 7 lines · Gary Thomas

Using latest master 296866c38e1b88df42d66bdc32cfed2d5212914c

bitbake poky-image-sato fails with the log http://www.mlbassoc.com/poky/log.do_compile-beagleboard

You can see this with the simpler case
bitbake binutils

Belay that - I had Nitin's GCC 4.5.2 changes enabled, so this error probably only applies there.

Sorry

Signature · 4 lines
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------
#2 lore raw
Quoted 6 lines · Gary Thomas
Quoted 5 lines · Gary Thomas

Using latest master 296866c38e1b88df42d66bdc32cfed2d5212914c

bitbake poky-image-sato fails with the log
http://www.mlbassoc.com/poky/log.do_compile-beagleboard

Quoted 6 lines
Quoted 3 lines

You can see this with the simpler case
bitbake binutils

Belay that - I had Nitin's GCC 4.5.2 changes enabled, so this error probably only applies there.

I'm currently booting the poky-image-minimal on the beagleboard in the following configs:

meta w/ linux-yocto

meta w/ linux-yocto-stable

meta
meta-linaro

There appears to be an issue with the serial driver, changing it to ttyS2 from ttyO2 in beagleboard.conf seems to resolve it for the linaro kernel. I'm looking into correcting the serial bits. The network interface isn't working on the linaro kernel, but it does on the two yocto kernels. I'm working on this as well.

Signature · 3 lines
Darren Hart
Intel Open Source Technology Center
Yocto Project - Linux Kernel