Can't build for BeagleBoard
Quoted 7 lines · Gary Thomas
Using latest master
296866c38e1b88df42d66bdc32cfed2d5212914cbitbake poky-image-sato fails with the log http://www.mlbassoc.com/poky/log.do_compile-beagleboard
You can see this with the simpler case
bitbake binutils
Belay that - I had Nitin's GCC 4.5.2 changes enabled, so this error probably only applies there.
Sorry
Signature · 4 lines
------------------------------------------------------------ Gary Thomas | Consulting for the MLB Associates | Embedded world ------------------------------------------------------------
Quoted 6 lines · Gary Thomas
Quoted 5 lines · Gary Thomas
Using latest master
296866c38e1b88df42d66bdc32cfed2d5212914cbitbake poky-image-sato fails with the log
http://www.mlbassoc.com/poky/log.do_compile-beagleboard
Quoted 6 lines
Quoted 3 lines
You can see this with the simpler case
bitbake binutilsBelay that - I had Nitin's GCC 4.5.2 changes enabled, so this error probably only applies there.
I'm currently booting the poky-image-minimal on the beagleboard in the following configs:
meta w/ linux-yocto
meta w/ linux-yocto-stable
meta
meta-linaro
There appears to be an issue with the serial driver, changing it to ttyS2 from ttyO2 in beagleboard.conf seems to resolve it for the linaro kernel. I'm looking into correcting the serial bits. The network interface isn't working on the linaro kernel, but it does on the two yocto kernels. I'm working on this as well.
Signature · 3 lines
Darren Hart Intel Open Source Technology Center Yocto Project - Linux Kernel