Skip to contentSkip to conversation

ARM: at91: Ethernut 5 board support

PATCH Superseded Tim Schendekehl 1 participant 1 message Mar 5, 2012

Subsystems (3)

v1 of 4 Superseded Latest is v4 →

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: at91: Ethernut 5 board support

Add support for the Ethernut 5 open hardware design, based on Atmel's AT91SAM9XE512 SoC.

---
 arch/arm/mach-at91/Kconfig           |    7 +
 arch/arm/mach-at91/Makefile          |    1 +
 arch/arm/mach-at91/board-ethernut5.c |  280 ++++++++++++++++++++++++++++++++++
 3 files changed, 288 insertions(+), 0 deletions(-)
 create mode 100644 arch/arm/mach-at91/board-ethernut5.c
arch/arm/mach-at91/Kconfig +7 -0
index 71feb00..88ee70a 100644
@@ -239,6 +239,13 @@ config MACH_CAM60
 	  Select this if you are using KwikByte's KB9260 (CAM60) board based on the Atmel AT91SAM9260.
 	  <http://www.kwikbyte.com/KB9260.html>
 
+config MACH_ETHERNUT5
+	bool "Ethernut 5 board"
+	select HAVE_AT91_DATAFLASH_CARD
+	help
+	  Select this if you are using an Ethernut 5 board
+	  <http://www.ethernut.de/en/hardware/enut5/>
+
 config MACH_SAM9_L9260
 	bool "Olimex SAM9-L9260 board"
 	select HAVE_AT91_DATAFLASH_CARD
arch/arm/mach-at91/Makefile +1 -0
index 705e1fb..e8ef87d 100644
@@ -43,6 +43,7 @@ obj-$(CONFIG_MACH_RSI_EWS)	+= board-rsi-ews.o
 # AT91SAM9260 board-specific support
 obj-$(CONFIG_MACH_AT91SAM9260EK) += board-sam9260ek.o
 obj-$(CONFIG_MACH_CAM60)	+= board-cam60.o
+obj-$(CONFIG_MACH_ETHERNUT5)	+= board-ethernut5.o
 obj-$(CONFIG_MACH_SAM9_L9260)	+= board-sam9-l9260.o
 obj-$(CONFIG_MACH_USB_A9260)	+= board-usb-a926x.o
 obj-$(CONFIG_MACH_QIL_A9260)	+= board-qil-a9260.o
arch/arm/mach-at91/board-ethernut5.c new file +280 -0

280 lines not on this page · raw message

Signature · 1 line
1.7.1