ARM: at91: Ethernut 5 board support
PATCH 1/1 ARM: at91: Ethernut 5 board support
Add support for the Ethernut 5 open hardware design, based on Atmel's AT91SAM9XE512 SoC.
Signed-off-by Tim Schendekehl <[email protected]>
--- arch/arm/mach-at91/Kconfig | 7 + arch/arm/mach-at91/Makefile | 1 + arch/arm/mach-at91/board-ethernut5.c | 280 ++++++++++++++++++++++++++++++++++ 3 files changed, 288 insertions(+), 0 deletions(-) create mode 100644 arch/arm/mach-at91/board-ethernut5.c
arch/arm/mach-at91/Kconfig +7 -0
@@ -239,6 +239,13 @@ config MACH_CAM60 Select this if you are using KwikByte's KB9260 (CAM60) board based on the Atmel AT91SAM9260. <http://www.kwikbyte.com/KB9260.html> +config MACH_ETHERNUT5 + bool "Ethernut 5 board" + select HAVE_AT91_DATAFLASH_CARD + help + Select this if you are using an Ethernut 5 board + <http://www.ethernut.de/en/hardware/enut5/> + config MACH_SAM9_L9260 bool "Olimex SAM9-L9260 board" select HAVE_AT91_DATAFLASH_CARD
arch/arm/mach-at91/Makefile +1 -0
@@ -43,6 +43,7 @@ obj-$(CONFIG_MACH_RSI_EWS) += board-rsi-ews.o # AT91SAM9260 board-specific support obj-$(CONFIG_MACH_AT91SAM9260EK) += board-sam9260ek.o obj-$(CONFIG_MACH_CAM60) += board-cam60.o +obj-$(CONFIG_MACH_ETHERNUT5) += board-ethernut5.o obj-$(CONFIG_MACH_SAM9_L9260) += board-sam9-l9260.o obj-$(CONFIG_MACH_USB_A9260) += board-usb-a926x.o obj-$(CONFIG_MACH_QIL_A9260) += board-qil-a9260.o
arch/arm/mach-at91/board-ethernut5.c new file +280 -0
280 lines not on this page · raw message
Signature · 1 line
1.7.1