Skip to contentSkip to conversation

snd_pcm_sw_params_set_start_threshold() functionality

DISCUSSION irfanks 1 participant 2 messages Oct 29, 2012

lore
Share & tools
lore

irfanks

author
#0 lore raw

Hello,

snd_pcm_sw_params_set_start_threshold() API description
explains, "PCM is automatically started when playback frames available to PCM are >= threshold"

I want to know, whether above pre-buffering(threshold)
mechanism is only during the start of playback ?
OR
Also if my playback device goes to XRUN state, Again next
time when i prepare my playback device using snd_pcm_prepare(). Again the prebuffering (threshold) will occur since i have set snd_pcm_sw_params_set_start_threshold() to N periods in software params.

Best Regards,
Thanks in advance,
Irfan...

author
#1 lore raw

Please let me know if my below understanding is correct :

snd_pcm_sw_params_set_start_threshold() explains :
"PCM is automatically started when playback frames available to PCM are >= threshold or when requested capture frames are >= threshold"

PCM has below states :

SND_PCM_STATE_OPEN Open
SND_PCM_STATE_SETUP Setup installed
SND_PCM_STATE_PREPARED Ready to start
SND_PCM_STATE_RUNNING Running
SND_PCM_STATE_XRUN Stopped: underrun (playback) or overrun (capture) detected
SND_PCM_STATE_DRAINING Draining: running (playback) or stopped (capture)
SND_PCM_STATE_PAUSED Paused
SND_PCM_STATE_SUSPENDED Hardware is suspended
SND_PCM_STATE_DISCONNECTED Hardware is disconnected

When ever underrun occurs, PCM device state goes to XRUN state.
To bring back the PCM playback device to playback {Ready to start}, we use snd_pcm_prepare().

*Thus snd_pcm_sw_params_set_start_threshold() should again prebuffer(threshold) X periods of data {which we have set in software params}, once again after the XRUN state is recovered.*

Thanks and regards,
Irfan

Quoted 15 lines · irfanks

Hello,

snd_pcm_sw_params_set_start_threshold() API description
explains, "PCM is automatically started when playback frames available to PCM are >= threshold"

I want to know, whether above pre-buffering(threshold)
mechanism is only during the start of playback ?
OR
Also if my playback device goes to XRUN state, Again next
time when i prepare my playback device using snd_pcm_prepare(). Again the prebuffering (threshold) will occur since i have set snd_pcm_sw_params_set_start_threshold() to N periods in software params.

Best Regards,
Thanks in advance,
Irfan...