Skip to contentSkip to conversation

access to hardware registers using KGDB on ARM

DISCUSSION Андрей Скворцов 1 participant 1 message Apr 24, 2013

lore
Share & tools
lore
#0 lore raw

Hello everyone,

I have arm SoC AM3517 (Cortex-A8) running linux 2.6.32. I am trying to access hardware registers using kgdb. I can connect to the board via RS232, can read variables in kernel space, control processes using breakpoints, but I can't read hardware register.

For example, I am trying to read UART3 registers. Information about UART3 is saved in structure:

static struct plat_serial8250_port serial_platform_data2[] = {
    {
        .mapbase    = OMAP_UART3_BASE,
        .irq        = 74,
        .iotype        = UPIO_MEM,
        .regshift    = 2,
	...
    }
}

mapbase is a physical address. According to the Technical Reference Manual is should be 0x49020000.

I checked this field using kgdb:

(gdb) p/x serial_platform_data2[0].mapbase
$34 = 0x49020000

This structure has the field membase. As I understand, it contains virtual address of the mapbase physical address. This field is initialized on UART init via function ioremap().

I checked this field as well:

(gdb) p/x serial_platform_data2[0].membase
$35 = 0xfb020000

Now I am trying to read register MCR_REG, that has offset 0x10 from the base address.

(gdb) x serial_platform_data2[0].membase+0x10
0xfb020010: Cannot access memory at address 0xfb020010

(gdb) x serial_platform_data2[0].mapbase+0x10
0x49020010: Cannot access memory at address 0x49020010

As I understand, the membase address should work. Right? Why has access failed? Is it kgdb limitation?

Signature · 2 lines
Best regards,
Andrey Skvortsov