sigmadsp: adau1701: Version mismatch while loading firmware in 3.18.3
Hello Lars-Peter,
i followed the instructions on:
http://wiki.analog.com/resources/tools-software/linux-software/sigmadsp_genfirmware
and built the firmware from my xml-file. But when the driver loads, I always get:
adau1701 2-0034: Failed to load firmware: Invalid version 2. Supported firmware versions: 1
adau1701 2-0034: Failed to load firmware
adau1701 2-0034: ASoC: can't set adau1701 hw params: -22
I have been using that .xml/.bin file in 3.14.13 for some time, but now in 3.18.3 I always get the version mismatch from above.
What am I doing wrong?
regards
pascal
Quoted 9 lines · Pascal Huerst
Hello Lars-Peter,
i followed the instructions on:
http://wiki.analog.com/resources/tools-software/linux-software/sigmadsp_genfirmware
and built the firmware from my xml-file. But when the driver loads, I always get:
Quoted 7 lines
adau1701 2-0034: Failed to load firmware: Invalid version 2. Supported firmware versions: 1
adau1701 2-0034: Failed to load firmware
adau1701 2-0034: ASoC: can't set adau1701 hw params: -22I have been using that .xml/.bin file in 3.14.13 for some time, but now in 3.18.3 I always get the version mismatch from above.
Hi,
Are you sure that the you were previously using a v2 firmware file? v2 was not supported until recently and loading it with the v1 loader would just result in garbage being written to the device.
The patch[1] that adds support for v2 is pretty standalone and you should be able to backport it to v3.18.
- Lars
Quoted 16 lines · Lars-Peter Clausen
Quoted 15 lines · Pascal Huerst
Hello Lars-Peter,
i followed the instructions on:
http://wiki.analog.com/resources/tools-software/linux-software/sigmadsp_genfirmware
and built the firmware from my xml-file. But when the driver loads, I always get:
adau1701 2-0034: Failed to load firmware: Invalid version 2. Supported firmware versions: 1
adau1701 2-0034: Failed to load firmware
adau1701 2-0034: ASoC: can't set adau1701 hw params: -22
Quoted 8 lines
Quoted 2 lines
I have been using that .xml/.bin file in 3.14.13 for some time, but now in 3.18.3 I always get the version mismatch from above.
Hi,
Are you sure that the you were previously using a v2 firmware file? v2 was not supported until recently and loading it with the v1 loader would just result in garbage being written to the device.
I have been using the firmware file for more than a year without any problems on 3.14.23, so I assume it is v1. I don't know why the driver tells me it's v2, however. Maybe my tree is messed up.
If I port adau1701.{c,h} and sigmadsp.{c,h} from 3.14.23 to 3.18.3, it works. I think I have to look deeper into that...
Quoted 2 lines
The patch[1] that adds support for v2 is pretty standalone and you should be able to backport it to v3.18.
If I cherry-pick that in, the message is gone, but still, I don't have no output.