Getting a 'no-ack' tx status?
Someone reported to me that they never see the tx_done->no_ack flag set on their AP, even when stations are falling off the network due to not receiving ACKs.
if (tx_done->no_ack) info->flags &= ~IEEE80211_TX_STAT_ACK;
I am having no luck finding the corresponding code in the 10.1.467 firmware that would cause this to work, but maybe I am just not looking in the right place.
Has anyone done any testing to see if ath10k actually reports ACK failures properly back up the stack?
Thanks,
Ben
Signature · 8 lines
Ben Greear <[email protected]> Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
I think I managed to hack the CT firmware to return the tx-completion status (OK, XRETRY, DROP) when it is returning the tx-rate info, and patched the driver to pay attention to it...
A brief test showed some failed-retry counters reported by the mac80211 stack, so that looks promising.
Will do some more testing when I get a chance.
Thanks,
Ben
Quoted 18 lines · Ben Greear
Someone reported to me that they never see the
tx_done->no_ackflag set on their AP, even when stations are falling off the network due to not receiving ACKs.if (tx_done->no_ack) info->flags &= ~IEEE80211_TX_STAT_ACK;I am having no luck finding the corresponding code in the 10.1.467 firmware that would cause this to work, but maybe I am just not looking in the right place.
Has anyone done any testing to see if ath10k actually reports ACK failures properly back up the stack?
Thanks,
Ben
Signature · 7 lines
Ben Greear <[email protected]> Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
Quoted 8 lines · Ben Greear
Someone reported to me that they never see the
tx_done->no_ackflag set on their AP, even when stations are falling off the network due to not receiving ACKs.if (tx_done->no_ack) info->flags &= ~IEEE80211_TX_STAT_ACK;
Quoted 6 lines
I am having no luck finding the corresponding code in the 10.1.467 firmware that would cause this to work, but maybe I am just not looking in the right place.
Has anyone done any testing to see if ath10k actually reports ACK failures properly back up the stack?
IIRC 10.1 firmware had a missing condition for that so it reported all frames as ACKed even if that wasn't the case.
I believe this has been fixed in 10.2.
Michał
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k