405EP U-boot/Linux Question (CFG_OCM_DATA_ADDR)
Hi guys,
I was wondering if some one could give me an hand with OCM for PPC405EP
So my goal is to Access *CFG_BOOTCOUNT_ADDR *value in Linux based on
http://www.denx.de/wiki/view/DULG/UBootBootCountLimit
In u-boot it works fine but ... but how to i talk to this memory range in linux.
I tried the following but no luck.
ulong * save_addr = ioremap( (CFG_OCM_DATA_ADDR + CFG_BOOTCOUNT_ADDR),8
);
if (save_addr[1] != BOOTCOUNT_MAGIC)
return 0;
else
return save_addr[0];u-boot config file setting:
#define *CFG_OCM_DATA_ADDR* 0xF8000000
#define CFG_OCM_DATA_SIZE 0x1000 #define CFG_INIT_RAM_ADDR CFG_OCM_DATA_ADDR /* inside of OCM */ #define CFG_INIT_RAM_END CFG_OCM_DATA_SIZE /* End of used area in RAM
*/
#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data
*/
#define CFG_GBL_DATA_OFFSET (CFG_INIT_RAM_END - CFG_GBL_DATA_SIZE) /* reserve some memory for POST and BOOT limit info */ #define CFG_INIT_SP_OFFSET (CFG_GBL_DATA_OFFSET - 24)
/* extra data in OCM */
#define CFG_POST_WORD_ADDR (CFG_GBL_DATA_OFFSET - 4) #define CFG_POST_MAGIC (CFG_OCM_DATA_ADDR + CFG_GBL_DATA_OFFSET - 8) #define CFG_POST_VAL (CFG_OCM_DATA_ADDR + CFG_GBL_DATA_OFFSET - 12)
#ifdef CONFIG_BOOTCOUNT_LIMIT /* reserve 2 word for bootcount limit */ #define CFG_BOOTCOUNT_ADDR (CFG_GBL_DATA_OFFSET - 24) //#define *CFG_BOOTCOUNT_ADDR* (CFG_OCM_DATA_ADDR + CFG_GBL_DATA_OFFSET -
16)
#endif
Any suggestion?
Quoted 4 lines · Pawel Pastuszak
I was wondering if some one could give me an hand with OCM for PPC405EP
So my goal is to Access
*CFG_BOOTCOUNT_ADDR*value in Linux based on
http://www.denx.de/wiki/view/DULG/UBootBootCountLimit
Please note that its CONFIG_SYS_BOOTCOUNT_ADDR now.
Quoted 11 lines
In u-boot it works fine but ... but how to i talk to this memory range in linux.
I tried the following but no luck.
ulong *save_addr= ioremap( (CFG_OCM_DATA_ADDR+ CFG_BOOTCOUNT_ADDR),8
);if (save_addr[1] != BOOTCOUNT_MAGIC) return 0; else return save_addr[0];
And what's the result of the above code? Do you get an exception? Or some unreasonable values?
Which kernel version are you using?
Best regards,
Stefan
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de
=====================================================================