Skip to contentSkip to conversation

Sempron 2800+

DISCUSSION Arik Raffael Funke 2 participants 3 messages Sep 12, 2006

lore
Share & tools
lore
#0 lore raw

Hello,

I am using kernel version 2.6.17.11 with built-in cpufreq support on a AMD Sempron 2800+. However, I do not have the directory /sys/devices/system/cpu/cpu0/cpufreq/

Can anybody tell me why? Does my cpu not support cpufreq or have i forgotten to select some kernel modules/configuration?

Cheers,
Arik

#1 lore raw
Quoted 6 lines

I am using kernel version 2.6.17.11 with built-in cpufreq support on a AMD Sempron 2800+. However, I do not have the directory /sys/devices/system/cpu/cpu0/cpufreq/

Can anybody tell me why? Does my cpu not support cpufreq or have i forgotten to select some kernel modules/configuration?

What does dmesg | grep powern report?

I suspect that your Sempron doesn't have the bit enabled that tells the driver it supports PowerNow!. Thus, the driver doesn't load. I haven't had a chance to determine if there's a large batch of Sempron 2800s that don't support PN!, or if they just use a different bit to indicate that support.

-Mark Langsdorf
AMD, Inc.

#2 lore raw
Quoted 7 lines · Mark
Quoted 6 lines

I am using kernel version 2.6.17.11 with built-in cpufreq support on a AMD Sempron 2800+. However, I do not have the directory /sys/devices/system/cpu/cpu0/cpufreq/

Can anybody tell me why? Does my cpu not support cpufreq or have i forgotten to select some kernel modules/configuration?

Quoted 8 lines

What does dmesg | grep powern report?

I suspect that your Sempron doesn't have the bit enabled that tells the driver it supports PowerNow!. Thus, the driver doesn't load. I haven't had a chance to determine if there's a large batch of Sempron 2800s that don't support PN!, or if they just use a different bit to indicate that support.

dmesg | grep powern reports nothing at all... Is that supposed to be a good or bad thing? I fear for the latter. ;-)

Is there anything else I could provide to help with diagnosis?

Regards,
Arik