Skip to contentSkip to conversation

2.6.17-rc5-mm3 - USB issues

DISCUSSION Pete Zaitcev 1 participant 1 message Jun 20, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 11 lines · Johny Ågotnes

My USB hub isn't recognised with the latest -mm series, whereas with 2.6.16 vanilla it is picked up & used immediately.

The error I get in dmesg is;

hub 4-0:1.0: USB hub found
hub 4-0:1.0: 2 ports detected
usb 1-4: new high speed USB device using ehci_hcd and address 3 ehci_hcd 0000:00:10.3: Unlink after no-IRQ? Controller is probably using the wrong IRQ.
usb 1-4: device not accepting address 3, error -110

Compare the working dmesg and non-working dmesg. Likely, the interrupt assignment was messed up.

-- Pete