2.6.17-rc5-mm3 - USB issues
Quoted 11 lines · Johny Ågotnes
My USB hub isn't recognised with the latest -mm series, whereas with 2.6.16 vanilla it is picked up & used immediately.
The error I get in dmesg is;
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 2 ports detected
usb 1-4: new high speed USB device usingehci_hcdand address 3ehci_hcd0000:00:10.3: Unlink after no-IRQ? Controller is probably using the wrong IRQ.
usb 1-4: device not accepting address 3, error -110
Compare the working dmesg and non-working dmesg. Likely, the interrupt assignment was messed up.
-- Pete