sunxi: mmc support
Subsystems (3)
PATCH 7/8 sunxi: mmc support
This adds support for the MMC controller on the Allwinner A20 (sun7i) processor.
---
v5.1: Based on 3f5ff92b1503 "sunxi: add comments to pll1_para array."
- Drop unused CONFIG_MMC1_PG option
- Make comments in mmc_pinmux_setup be consistent (always Function-Pin, not half Pin-Function).
v5: Based on 3f5ff92b1503 "sunxi: add comments to pll1_para array."
- No changes required
v4: Based on d9fe0a1e061e "sunxi: mksunxiboot: remove unnecessary casts."
- Moved pinmux setup from drivers/mmc/sunxi_mmc.c to board/sunxi/board.c
- Use setbits_le32 to manipulate the ahb0 gate.
v3: Based on c89867dca2e9 "sunxi: clocks: clock_get_pll5 prototype and coding style".
v2: Based on u-boot-sunxi.git#sunxi d9aa5dd3d15c "sunxi: mmc:
checkpatch whitespace fixes" with v2014.04-rc2 merged in:
- use proper gpio interfaces, removing awkward casts and some magic numbers.
- remove magic numbers
- other cleanups
v1: Based on u-boot-sunxi.git#sunxi commit d854c4de2f57 "arm: Handle .gnu.hash section in ldscripts" vs v2014.01.
mmc: drop debug
--- arch/arm/include/asm/arch-sunxi/mmc.h | 124 +++++++++ board/sunxi/board.c | 63 +++++ drivers/mmc/Makefile | 1 + drivers/mmc/sunxi_mmc.c | 503 ++++++++++++++++++++++++++++++++++ include/configs/sunxi-common.h | 11 + 5 files changed, 702 insertions(+) create mode 100644 arch/arm/include/asm/arch-sunxi/mmc.h create mode 100644 drivers/mmc/sunxi_mmc.c
arch/arm/include/asm/arch-sunxi/mmc.h new file +124 -0
@@ -0,0 +1,124 @@ +/* +* (C) Copyright 2007-2011 +* Allwinner Technology Co., Ltd. <www.allwinnertech.com> +* Aaron <[email protected]> +* +* MMC register definition for allwinner sunxi platform. +* +* SPDX-License-Identifier: GPL-2.0+ +*/ + +#ifndef _SUNXI_MMC_H +#define _SUNXI_MMC_H + +#include <linux/types.h> + +struct sunxi_mmc { +u32 gctrl;/* 0x00 global control */ +u32 clkcr;/* 0x04 clock control */ +u32 timeout;/* 0x08 time out */ +u32 width;/* 0x0c bus width */ +u32 blksz;/* 0x10 block size */ +u32 bytecnt;/* 0x14 byte count */ +u32 cmd;/* 0x18 command */ +u32 arg;/* 0x1c argument */ +u32 resp0;/* 0x20 response 0 */ +u32 resp1;/* 0x24 response 1 */ +u32 resp2;/* 0x28 response 2 */ +u32 resp3;/* 0x2c response 3 */ +u32 imask;/* 0x30 interrupt mask */ +u32 mint;/* 0x34 masked interrupt status */ +u32 rint;/* 0x38 raw interrupt status */ +u32 status;/* 0x3c status */ +u32 ftrglevel;/* 0x40 FIFO threshold watermark*/ +u32 funcsel;/* 0x44 function select */ +u32 cbcr;/* 0x48 CIU byte count */ +u32 bbcr;/* 0x4c BIU byte count */ +u32 dbgc;/* 0x50 debug enable */ +u32 res0[11 ]; +u32 dmac;/* 0x80 internal DMA control */ +u32 dlba;/* 0x84 internal DMA descr list base address */ +u32 idst;/* 0x88 internal DMA status */ +u32 idie;/* 0x8c internal DMA interrupt enable */ +u32 chda;/* 0x90 */ +u32 cbda;/* 0x94 */ +u32 res1[26 ]; +u32 fifo;/* 0x100 FIFO access address */ +}; + +#define SUNXI_MMC_CLK_POWERSAVE (0x1 << 17) +#define SUNXI_MMC_CLK_ENABLE (0x1 << 16) +#define SUNXI_MMC_CLK_DIVIDER_MASK (0xff) + +#define SUNXI_MMC_GCTRL_SOFT_RESET (0x1 << 0) +#define SUNXI_MMC_GCTRL_FIFO_RESET (0x1 << 1) +#define SUNXI_MMC_GCTRL_DMA_RESET (0x1 << 2) +#define SUNXI_MMC_GCTRL_RESET (SUNXI_MMC_GCTRL_SOFT_RESET|\ + SUNXI_MMC_GCTRL_FIFO_RESET|\ + SUNXI_MMC_GCTRL_DMA_RESET) +#define SUNXI_MMC_GCTRL_DMA_ENABLE (0x1 << 5) +#define SUNXI_MMC_GCTRL_ACCESS_BY_AHB (0x1 << 31) + +#define SUNXI_MMC_CMD_RESP_EXPIRE (0x1 << 6) +#define SUNXI_MMC_CMD_LONG_RESPONSE (0x1 << 7) +#define SUNXI_MMC_CMD_CHK_RESPONSE_CRC (0x1 << 8) +#define SUNXI_MMC_CMD_DATA_EXPIRE (0x1 << 9) +#define SUNXI_MMC_CMD_WRITE (0x1 << 10) +#define SUNXI_MMC_CMD_AUTO_STOP (0x1 << 12) +#define SUNXI_MMC_CMD_WAIT_PRE_OVER (0x1 << 13) +#define SUNXI_MMC_CMD_SEND_INIT_SEQ (0x1 << 15) +#define SUNXI_MMC_CMD_UPCLK_ONLY (0x1 << 21) +#define SUNXI_MMC_CMD_START (0x1 << 31) + +#define SUNXI_MMC_RINT_RESP_ERROR (0x1 << 1) +#define SUNXI_MMC_RINT_COMMAND_DONE (0x1 << 2) +#define SUNXI_MMC_RINT_DATA_OVER (0x1 << 3) +#define SUNXI_MMC_RINT_TX_DATA_REQUEST (0x1 << 4) +#define SUNXI_MMC_RINT_RX_DATA_REQUEST (0x1 << 5) +#define SUNXI_MMC_RINT_RESP_CRC_ERROR (0x1 << 6) +#define SUNXI_MMC_RINT_DATA_CRC_ERROR (0x1 << 7) +#define SUNXI_MMC_RINT_RESP_TIMEOUT (0x1 << 8) +#define SUNXI_MMC_RINT_DATA_TIMEOUT (0x1 << 9) +#define SUNXI_MMC_RINT_VOLTAGE_CHANGE_DONE (0x1 << 10) +#define SUNXI_MMC_RINT_FIFO_RUN_ERROR (0x1 << 11) +#define SUNXI_MMC_RINT_HARD_WARE_LOCKED (0x1 << 12) +#define SUNXI_MMC_RINT_START_BIT_ERROR (0x1 << 13) +#define SUNXI_MMC_RINT_AUTO_COMMAND_DONE (0x1 << 14) +#define SUNXI_MMC_RINT_END_BIT_ERROR (0x1 << 15) +#define SUNXI_MMC_RINT_SDIO_INTERRUPT (0x1 << 16) +#define SUNXI_MMC_RINT_CARD_INSERT (0x1 << 30) +#define SUNXI_MMC_RINT_CARD_REMOVE (0x1 << 31) +#define SUNXI_MMC_RINT_INTERRUPT_ERROR_BIT \ + (SUNXI_MMC_RINT_RESP_ERROR | \ + SUNXI_MMC_RINT_RESP_CRC_ERROR | \ + SUNXI_MMC_RINT_DATA_CRC_ERROR | \ + SUNXI_MMC_RINT_RESP_TIMEOUT | \ + SUNXI_MMC_RINT_DATA_TIMEOUT | \ + SUNXI_MMC_RINT_VOLTAGE_CHANGE_DONE | \ + SUNXI_MMC_RINT_FIFO_RUN_ERROR | \ + SUNXI_MMC_RINT_HARD_WARE_LOCKED | \ + SUNXI_MMC_RINT_START_BIT_ERROR | \ + SUNXI_MMC_RINT_END_BIT_ERROR)/* 0xbfc2 */ +#define SUNXI_MMC_RINT_INTERRUPT_DONE_BIT \ + (SUNXI_MMC_RINT_AUTO_COMMAND_DONE | \ + SUNXI_MMC_RINT_DATA_OVER | \ + SUNXI_MMC_RINT_COMMAND_DONE | \ + SUNXI_MMC_RINT_VOLTAGE_CHANGE_DONE) + +#define SUNXI_MMC_STATUS_RXWL_FLAG (0x1 << 0) +#define SUNXI_MMC_STATUS_TXWL_FLAG (0x1 << 1) +#define SUNXI_MMC_STATUS_FIFO_EMPTY (0x1 << 2) +#define SUNXI_MMC_STATUS_FIFO_FULL (0x1 << 3) +#define SUNXI_MMC_STATUS_CARD_PRESENT (0x1 << 8) +#define SUNXI_MMC_STATUS_CARD_DATA_BUSY (0x1 << 9) +#define SUNXI_MMC_STATUS_DATA_FSM_BUSY (0x1 << 10) + +#define SUNXI_MMC_IDMAC_RESET (0x1 << 0) +#define SUNXI_MMC_IDMAC_FIXBURST (0x1 << 1) +#define SUNXI_MMC_IDMAC_ENABLE (0x1 << 7) + +#define SUNXI_MMC_IDIE_TXIRQ (0x1 << 0) +#define SUNXI_MMC_IDIE_RXIRQ (0x1 << 1) + +int sunxi_mmc_init (int sdc_no); +#endif /* _SUNXI_MMC_H */
board/sunxi/board.c +63 -0
75 lines not on this page · raw message
drivers/mmc/Makefile +1 -0
@@ -28,6 +28,7 @@ obj-$(CONFIG_SPEAR_SDHCI) += spear_sdhci.o obj-$(CONFIG_TEGRA_MMC) += tegra_mmc.o obj-$(CONFIG_DWMMC) += dw_mmc.o obj-$(CONFIG_EXYNOS_DWMMC) += exynos_dw_mmc.o +obj-$(CONFIG_MMC_SUNXI) += sunxi_mmc.o obj-$(CONFIG_ZYNQ_SDHCI) += zynq_sdhci.o obj-$(CONFIG_SOCFPGA_DWMMC) += socfpga_dw_mmc.o ifdef CONFIG_SPL_BUILD
drivers/mmc/sunxi_mmc.c new file +503 -0
503 lines not on this page · raw message
include/configs/sunxi-common.h +11 -0
@@ -59,6 +59,16 @@#define CONFIG_CMDLINE_TAG #define CONFIG_INITRD_TAG +/* mmc config */ +#define CONFIG_MMC +#define CONFIG_GENERIC_MMC +#define CONFIG_CMD_MMC +#define CONFIG_MMC_SUNXI +#define CONFIG_MMC_SUNXI_SLOT 0 +#define CONFIG_MMC_SUNXI_USE_DMA +#define CONFIG_ENV_IS_IN_MMC +#define CONFIG_SYS_MMC_ENV_DEV 0/* first detected MMC controller */ +/* 4MB of malloc() pool */ #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + (4 << 20))
@@ -94,6 +104,7 @@#define CONFIG_SYS_MONITOR_LEN (512 << 10)/* 512 KiB */ #define CONFIG_IDENT_STRING " Allwinner Technology" +#define CONFIG_ENV_OFFSET (544 << 10)/* (8 + 24 + 512) KiB */ #define CONFIG_ENV_SIZE (128 << 10)/* 128 KiB */ #define CONFIG_EXTRA_ENV_SETTINGS \
Signature · 1 line
1.9.0