Skip to contentSkip to conversation

Problem routing packets using fwmark and netfilter

LARTC Stephane Ouellette 2 participants 4 messages Oct 7, 2002

lore
Share & tools
lore
#0 lore raw

Folks,

I will install in a near future a firewall/router on which two NICs
are connected to two different ISPs. I have read the iproute2 documentation and have been able to do some policy routing.

SUCCESSFUL TEST
---------------

Let's start with a simple ping test. I will ping two known computers on the internet using different gateways.

Following are the commands I have entered to enable policy routing using
the destination address as the routing key (Suppose that eth0 and
eth1 are the NICs connected to my ISPs):

ip route add $LAN1 dev eth0 src $MYADDR1 table lan1 ip route add default via $GATEWAY1 table lan1

ip route add $LAN2 dev eth1 src $MYADDR2 table lan2 ip route add default via $GATEWAY2 table lan2

ip rule add to $TESTMACHINE1 table lan1
ip rule add to $TESTMACHINE2 table lan2

Now, pinging $TESTMACHINE1 or $TESTMACHINE2 shows the expected behaviour.

MY PROBLEM
----------

Suppose I want to do some policy routing using the fwmark as a routing key. I should have entered the following commands:

iptables -t mangle -A OUTPUT -o eth0 -p icmp --icmp-type \
-d $TESTMACHINE1 -j MARK --set-mark 1
iptables -t mangle -A OUTPUT -o eth1 -p icmp --icmp-type \
-d $TESTMACHINE2 -j MARK --set-mark 2
ip rule add fwmark 1 table lan1
ip rule add fwmark 2 table lan2

Now, pinging $TESTMACHINE1 or $TESTMACHINE2 always uses the same gateway! The iptables rule counters increment as expected but it seems that the fwmark has no effect on routing !!!

MY CONFIGURATION
----------------

RedHat 7.2 on i686
Kernel 2.4.20-pre9 (all options related to advanced routing are enabled) Today's CVS snapshot of the Netfilter project

Any suggestion would be greatly appreciated !!!

Stephane.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 10 lines · Stephane Ouellette

MY PROBLEM
----------

Suppose I want to do some policy routing using the fwmark as a routing key. I should have entered the following commands:

iptables -t mangle -A OUTPUT -o eth0 -p icmp --icmp-type \
-d $TESTMACHINE1 -j MARK --set-mark 1
iptables -t mangle -A OUTPUT -o eth1 -p icmp --icmp-type \
-d $TESTMACHINE2 -j MARK --set-mark 2

I'd remove the '-o' option as you don't know yet where the packets would be routed to.

Ramin
PS. You forgot the --icmp-type argument. Did your linux box take these commands?

Quoted 17 lines

ip rule add fwmark 1 table lan1
ip rule add fwmark 2 table lan2

Now, pinging $TESTMACHINE1 or $TESTMACHINE2 always uses the same gateway! The iptables rule counters increment as expected but it seems that the fwmark has no effect on routing !!!

MY CONFIGURATION
----------------

RedHat 7.2 on i686
Kernel 2.4.20-pre9 (all options related to advanced routing are enabled) Today's CVS snapshot of the Netfilter project

Quoted 8 lines

Any suggestion would be greatly appreciated !!!

Stephane.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#2 lore raw
In reply to Stephane Ouellette
Quoted 18 lines · Ramin Alidousti
Quoted 10 lines · Stephane Ouellette

MY PROBLEM
----------

Suppose I want to do some policy routing using the fwmark as a routing key. I should have entered the following commands:

iptables -t mangle -A OUTPUT -o eth0 -p icmp --icmp-type \
-d $TESTMACHINE1 -j MARK --set-mark 1
iptables -t mangle -A OUTPUT -o eth1 -p icmp --icmp-type \
-d $TESTMACHINE2 -j MARK --set-mark 2

I'd remove the '-o' option as you don't know yet where the packets would be routed to.

Quoted 4 lines

Ramin
PS. You forgot the --icmp-type argument. Did your linux box take these commands?

Ramin,

I mistyped the commands I entered. In fact, you should read:

iptables -t mangle -A OUTPUT -p icmp --icmp-type echo-request \
-d $TESTMACHINE1 -j MARK --set-mark 1
iptables -t mangle -A OUTPUT -p icmp --icmp-type echo-request \
-d $TESTMACHINE2 -j MARK --set-mark 2

Stephane

Quoted 19 lines
Quoted 19 lines

ip rule add fwmark 1 table lan1
ip rule add fwmark 2 table lan2

Now, pinging $TESTMACHINE1 or $TESTMACHINE2 always uses the same gateway! The iptables rule counters increment as expected but it seems that the fwmark has no effect on routing !!!

MY CONFIGURATION
----------------

RedHat 7.2 on i686
Kernel 2.4.20-pre9 (all options related to advanced routing are enabled) Today's CVS snapshot of the Netfilter project

Quoted 10 lines
Quoted 8 lines

Any suggestion would be greatly appreciated !!!

Stephane.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#3 lore raw
In reply to Stephane Ouellette
Quoted 12 lines · Stephane Ouellette
Quoted 12 lines
Quoted 7 lines

Suppose I want to do some policy routing using the fwmark as a routing key. I should have entered the following commands:

iptables -t mangle -A OUTPUT -o eth0 -p icmp --icmp-type \
-d $TESTMACHINE1 -j MARK --set-mark 1
iptables -t mangle -A OUTPUT -o eth1 -p icmp --icmp-type \
-d $TESTMACHINE2 -j MARK --set-mark 2

I'd remove the '-o' option as you don't know yet where the packets would be routed to.

Quoted 8 lines
Quoted 4 lines

Ramin
PS. You forgot the --icmp-type argument. Did your linux box take these commands?

Ramin,

I mistyped the commands I entered. In fact, you should read:

That's what I figured :-)

But anyway, did you try these rules without the '-o' options? Another point is that if I remember correctly, either mangle or nat used to have problems with the OUTPUT chain in the past.

Ramin

Quoted 7 lines

iptables -t mangle -A OUTPUT -p icmp --icmp-type echo-request \
-d $TESTMACHINE1 -j MARK --set-mark 1
iptables -t mangle -A OUTPUT -p icmp --icmp-type echo-request \
-d $TESTMACHINE2 -j MARK --set-mark 2

Stephane

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/