Skip to contentSkip to conversation

tcng version 9h

LARTC Werner Almesberger 2 participants 2 messages Nov 7, 2003 – Nov 10, 2003

lore
Share & tools
lore
#0 lore raw

... is on SourceForge:

http://tcng.sourceforge.net/dist/tcng-9h.tar.gz
md5sum 9b7c520f92b312a5a00da12bad35f57d

See also http://tcng.sourceforge.net/

This release upgrades to the current 2.4 kernels, fixes a few minor glitches in the build system, and adds the options --no-manual and --with-manual to configure, so that tcng can be build without the documentation (also, configure uses --no-manual if it can't find latex or dvips).

The complete list of changes is below.

- Werner

----------------------------------- CHANGES -----------------------------------

Version 9h (7-NOV-2003)
-----------------------

- tcc/ext/Makefile: dependencies now only include .c files compiled in that directory, removing a warning when building RPMs
- split tcsim/Makefile into Makefile.unclean and Makefile.clean to avoid rebuilding klib and ulib when cleaning up after configuration changes
- configure is compatible with 2.4.22 and 2.4.23 (pre-release, tested with 2.4.23-pre9)
- setup.klib generates linux/smp.h needed for 2.4.22
- tcsim/trace.c and tcsim/modules/sch_discard.c adjust ..._drop prototype for interface change in 2.4.22
- setup.klib clears LANG before using sed on [^ -~]
- setup.klib adds "err" and "error_report" members to "struct sock" in af_netlink.c (for 2.4.23)
- updated kernel version example in tcng/README from 2.4.21 to 2.4.22
- configure: added options --no-manual and --with-manual (abbreviations -m and -M) to allow building tcng with or without the documentation (suggested by "raptor")
- configure: automatically assumes --no-manual if either latex or dvips is not in the PATH

Signature · 6 lines
  _________________________________________________________________________
 / Werner Almesberger, Buenos Aires, Argentina         [email protected] /
/_http://www.almesberger.net/____________________________________________/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw

Hi,

I tried compiled tcng withj HTB support using a vanilla 2.4.22 Linux Kernel. I downloaded iproute2 and the HTB patch from the locations suggested in the README file that comes with tcng.

After compilation, some tests fail doing a 'make test'.

For the first test, I used gcc 2.95.4 and gcc-3.0 (debian woody), and a test fails:

http://www.geocities.com/arhuaco/post/tcng-9hlog-debian-woody.txt

For the second one, I used gcc 3.3.2 (Debian - Knoppix 3.3), and it failed in a different way.

http://www.geocities.com/arhuaco/post/tcng-9hlog-knoppix-3.3.txt

The Knoppix kernel is not a vanilla kernel, but by reading tests/README I think it doesn't matter for the tests.

Well, I'd like to know if I'm doing something wrong.

Regards,
Nelson.-

Quoted 6 lines

Quoting Werner Almesberger (Fri, 7 Nov 2003 00:20:47 -0300 :
(snip ... )
.. is on SourceForge:
http://tcng.sourceforge.net/dist/tcng-9h.tar.gz
md5sum 9b7c520f92b312a5a00da12bad35f57d
(snip ... )

Signature · 8 lines
http://geocities.com/arhuaco

The first principle is that you must not fool yourself
and you are the easiest person to fool.
     -- Richard Feynman.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/