Skip to contentSkip to conversation

Loadbalancing on multiple eth rtl8139

LARTC Daniel Bergqvist [email protected] 1 participant 1 message Oct 17, 2000

lore
Share & tools
lore

Daniel Bergqvist [email protected]

author
#0 lore raw

<PRE>&gt;<i> Från: <A HREF="mailto:[email protected]">[email protected]</A> </I>&gt;<i> [mailto:<A HREF="mailto:[email protected]">[email protected]</A>]För bert hubert </I>&gt;<i>
</I>&gt;<i> On Mon, Oct 16, 2000 at 03:25:37PM +0200, Daniel Bergqvist wrote:
</I>&gt;<i>
</I>&gt;<i> &gt; This is basicly what I'm trying to do, but inside the sch_teql
</I>&gt;<i> driver. What
</I>&gt;<i> &gt; is the problems with tunnels?
</I>&gt;<i>
</I>&gt;<i> If your link saturates and you get packetloss, you get very weird
</I>&gt;<i> performance problems. Also, one lost packet stops *all* your IP traffic </I>&gt;<i> until it's resent.
</I>
My idea is to have to devices, teql_send0 and teql_receive0. The teql_send0
is the old teql0 device, but it also adds a serial number and a new IP
header so the packet goes to the teql_receive0 device at the remote end. I
know that the packets will be sent in order on each ethernet link to the
teql_receive0 device so it keeps a queue for each connection. If there is no
packet loss only one queue that will have packets. If both queues have a
packet it means we have a packet loss. The teql_receive0 device then sends
the packets in the original order.

&gt;<i>
</I>&gt;<i> &gt; Where is the archive for <A HREF="mailto:[email protected]">[email protected]</A>? </I>&gt;<i>
</I>&gt;<i> It appears to have died. I'll forward you the right messages.
</I>
I got it. Thanks!

&gt;<i> Regards,
</I>&gt;<i>
</I>&gt;<i> bert hubert
</I>
Regards,
Daniel

</PRE>