Skip to contentSkip to conversation

ColdFire: Relocate vector table - mcf5445x

PATCH New TsiChung Liew 1 participant 1 message Mar 18, 2010

lore
Share & tools
lore
#0 lore raw

PATCH 4/13 ColdFire: Relocate vector table - mcf5445x

Newer ColdFire processors family boot from address 0 instead of 0xFFnn_nnnn. When the boot flash base chip select is set at new location instead of 0, an un-predictable error will occur if there is an vector being trigger and refer it to an invalid address or the vector table handler is not existed at address 0.

---
 cpu/mcf5445x/cpu_init.c |    9 +++++++++
 1 files changed, 9 insertions(+), 0 deletions(-)
cpu/mcf5445x/cpu_init.c +9 -0
index 00e0ca6..8d51d35 100644
@@ -28,6 +28,7 @@
 #include <common.h>
 #include <watchdog.h>
 #include <asm/immap.h>
+#include <asm/processor.h>
 #include <asm/rtc.h>
 
 #if defined(CONFIG_CMD_NET)
@@ -105,6 +106,14 @@ void cpu_init_f(void)
 	fbcs->csmr5 = CONFIG_SYS_CS5_MASK;
 #endif
 
+	/*
+	 * now the flash base address is no longer at 0 (Newer ColdFire family
+	 * boot at address 0 instead of 0xFFnn_nnnn). The vector table must
+	 * also move to the new location.
+	 */
+	if (CONFIG_SYS_CS0_BASE != 0)
+		setvbr(CONFIG_SYS_CS0_BASE);
+
 #ifdef CONFIG_FSL_I2C
 	gpio->par_feci2c = GPIO_PAR_FECI2C_SCL_SCL | GPIO_PAR_FECI2C_SDA_SDA;
 #endif
Signature · 1 line
1.6.2.5