ColdFire: Relocate vector table - mcf5445x
PATCH 4/13 ColdFire: Relocate vector table - mcf5445x
Newer ColdFire processors family boot from address 0 instead of 0xFFnn_nnnn. When the boot flash base chip select is set at new location instead of 0, an un-predictable error will occur if there is an vector being trigger and refer it to an invalid address or the vector table handler is not existed at address 0.
Signed-off-by TsiChung Liew <[email protected]>
--- cpu/mcf5445x/cpu_init.c | 9 +++++++++ 1 files changed, 9 insertions(+), 0 deletions(-)
cpu/mcf5445x/cpu_init.c +9 -0
@@ -28,6 +28,7 @@#include <common.h> #include <watchdog.h> #include <asm/immap.h> +#include <asm/processor.h> #include <asm/rtc.h> #if defined(CONFIG_CMD_NET )
@@ -105,6 +106,14 @@ void cpu_init_f(void) fbcs->csmr5 =CONFIG_SYS_CS5_MASK ;#endif +/* +* now the flash base address is no longer at 0 (Newer ColdFire family +* boot at address 0 instead of 0xFFnn_nnnn). The vector table must +* also move to the new location. +*/ +if (CONFIG_SYS_CS0_BASE !=0 ) +setvbr (CONFIG_SYS_CS0_BASE ); +#ifdef CONFIG_FSL_I2C gpio->par_feci2c =GPIO_PAR_FECI2C_SCL_SCL |GPIO_PAR_FECI2C_SDA_SDA ;#endif
Signature · 1 line
1.6.2.5