ARM: dts: r8a7790-lager: Add VDD MPU regulator for DVFS
Subsystems (2)
RFC 1/4 ARM: dts: r8a7790-lager: Add VDD MPU regulator for DVFS
The CA15 cluster is capable of voltage scaling. Add the regulator in the i2c3 node, to allow the generic CPUFreq driver to use it.
Enable the i2c3 pin mux and the device node as well since the da9210 is connected to that bus.
Note: Vmin is set to 0.8v to allow experimentation only. There is no guaranty that the CPUs will still work at this voltage.
--- arch/arm/boot/dts/r8a7790-lager.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+)
arch/arm/boot/dts/r8a7790-lager.dts +21 -0
@@ -159,6 +159,11 @@ renesas,groups = "qspi_ctrl", "qspi_data4"; renesas,function = "qspi"; }; + + i2c3_pins: i2c3 { + renesas,groups = "i2c3"; + renesas,function = "i2c3"; + }; }; ðer {
@@ -240,3 +245,19 @@ cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>; status = "okay"; }; + +&i2c3 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c3_pins>; + status = "okay"; + + vdd_dvfs: regulator@68 { + compatible = "diasemi,da9210"; + reg = <0x68>; + + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <1000000>; + regulator-boot-on; + regulator-always-on; + }; +};
Signature · 1 line
1.8.3.2
Quoted 20 lines · Benoit Cousson
The CA15 cluster is capable of voltage scaling. Add the regulator in the i2c3 node, to allow the generic CPUFreq driver to use it.
Enable the i2c3 pin mux and the device node as well since the da9210 is connected to that bus.
Note: Vmin is set to 0.8v to allow experimentation only. There is no guaranty that the CPUs will still work at this voltage.
Signed-off-by Benoit Cousson <[email protected]>--- arch/arm/boot/dts/r8a7790-lager.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+)arch/arm/boot/dts/r8a7790-lager.dts +0
-0
arch/arm/boot/dts/r8a7790-lager.dts line 167
Quoted 9 lines
arch/arm/boot/dts/r8a7790-lager.dts +5
-0@@ -159,6 +159,11 @@ renesas,groups = "qspi_ctrl", "qspi_data4"; renesas,function = "qspi"; }; + + i2c3_pins: i2c3 { + renesas,groups = "i2c3"; + renesas,function = "i2c3"; + }; };
I thought i2c3 was a single function set of pins?
Signature · 2 lines
Ben Dooks http://www.codethink.co.uk/ Senior Engineer Codethink - Providing Genius