dt-bindings: adxl372: Document the adxl372 I2C bindings
Subsystems (2)
PATCH 3/3 dt-bindings: adxl372: Document the adxl372 I2C bindings
The adxl372 is designed to communicate in either SPI or I2C protocol. This patch adds the documentation of device tree bindings for adxl372 I2C.
Signed-off-by Stefan Popa <[email protected]>
--- Documentation/devicetree/bindings/iio/accel/adxl372.txt | 15 +++++++++++++-- 1 file changed, 13 insertions(+), 2 deletions(-)
Documentation/devicetree/bindings/iio/accel/adxl372.txt +13 -2
@@ -4,14 +4,25 @@ http://www.analog.com/media/en/technical-documentation/data-sheets/adxl372.pdf Required properties: - compatible : should be "adi,adxl372" - - reg: SPI chip select number for the device + - reg: the I2C address or SPI chip select number for the device + +Required properties for SPI bus usage: - spi-max-frequency: Max SPI frequency to use Optional properties: - interrupts: interrupt mapping for IRQ as documented in Documentation/devicetree/bindings/interrupt-controller/interrupts.txt -Example: +Example for a I2C device node: + + accelerometer@53 { + compatible = "adi,adxl372"; + reg = <0x53>; + interrupt-parent = <&gpio>; + interrupts = <25 IRQ_TYPE_EDGE_FALLING>; + }; + +Example for a SPI device node: accelerometer@0 { compatible = "adi,adxl372";
Signature · 1 line
2.7.4
Quoted 5 lines · On Tue, 4 Sep 2018 17:13:14 +0300 Stefan Popa <[email protected]> wrote:
The adxl372 is designed to communicate in either SPI or I2C protocol. This patch adds the documentation of device tree bindings for adxl372 I2C.
Signed-off-by Stefan Popa <[email protected]>
Applied.
Thanks,
Jonathan
Quoted 36 lines
--- Documentation/devicetree/bindings/iio/accel/adxl372.txt | 15 +++++++++++++-- 1 file changed, 13 insertions(+), 2 deletions(-)Documentation/devicetree/bindings/iio/accel/adxl372.txt +13
-2@@ -4,14 +4,25 @@ http://www.analog.com/media/en/technical-documentation/data-sheets/adxl372.pdf Required properties: - compatible : should be "adi,adxl372" - - reg: SPI chip select number for the device + - reg: the I2C address or SPI chip select number for the device + +Required properties for SPI bus usage: - spi-max-frequency: Max SPI frequency to use Optional properties: - interrupts: interrupt mapping for IRQ as documented in Documentation/devicetree/bindings/interrupt-controller/interrupts.txt -Example: +Example for a I2C device node: + + accelerometer@53 { + compatible = "adi,adxl372"; + reg = <0x53>; + interrupt-parent = <&gpio>; + interrupts = <25 IRQ_TYPE_EDGE_FALLING>; + }; + +Example for a SPI device node: accelerometer@0 { compatible = "adi,adxl372";