IDE device configure
Hello all,
I have supported the IDE Hard disk and the CF card on my custom board in U-BOOT.
They are using the same IDE bus.
If the hard disk and CF card are both inserted to the board, they are working well.But if I only insert the CF card, it can't be found. The issue seems like is the configuration of the device master/slave, how to configure which device as a master or as a slave?
Best regards
Terry
Quoted 2 lines · In message <[email protected]> you wrote:
The issue seems like is the configuration of the device master/slave,
Right.
Quoted 1 line
how to configure which device as a master or as a slave?
See the ATA spec.
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de The perversity of nature is nowhere better demonstrated by the fact that, when exposed to the same atmosphere, bread becomes hard while crackers become soft.