Skip to contentSkip to conversation

IDE device configure

U-Boot-Users terry qiu 2 participants 2 messages Feb 17, 2006

lore
Share & tools
lore

terry qiu

author
#0 lore raw

Hello all,

I have supported the IDE Hard disk and the CF card on my custom board in U-BOOT.

They are using the same IDE bus.
If the hard disk and CF card are both inserted to the board, they are working well.But if I only insert the CF card, it can't be found. The issue seems like is the configuration of the device master/slave, how to configure which device as a master or as a slave?

Best regards

Terry

#1 lore raw
Quoted 2 lines · In message <[email protected]> you wrote:

The issue seems like is the configuration of the device master/slave,

Right.

Quoted 1 line

how to configure which device as a master or as a slave?

See the ATA spec.

Best regards,

Wolfgang Denk

Signature · 5 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The perversity of nature is nowhere better demonstrated by  the  fact
that,  when  exposed to the same atmosphere, bread becomes hard while
crackers become soft.