MV64460 Burst reads from BootCS
Hi Roel
I've seen similar behavior using a MV64560 and power PC processor using a Windriver ICE.
Basically I could not read the MV internal registers correctly when I did not plug in a bootrom (leaving empty socket). Was reading zeroes anywhere in memory.
Somehow putting in even an empty Flash device allowed me to initialize the processor correctly and read/write MV registers and burn the flash via ICE.
- Wim
Quoted 6 lines
------------------------------
Message: 5
Date: Sun, 1 Oct 2006 20:19:12 +0200
From: "Roel Loeffen" <roel.loeffen@pr...>
Subject: [U-Boot-Users] MV64460 Burst reads from
BootCS
Quoted 3 lines
To: <u-boot-users@li...>
Message-ID:
<7826EB01AD927140A1DCF898FE63325D0D91B1@Ex...>
Quoted 5 lines
Content-Type: text/plain; charset="iso-8859-1"
Hi all,
We discover some serious problems accessing flash
at BootCS
Quoted 1 line
of the Marvell MV64460. It looks like burst reads
make the
Quoted 1 line
whole bridge hang. >From inside U-Boot as well as
using only
Quoted 3 lines
the BDI2000 debugger.
Reading the flash with bursts enabled (which is
default),
Quoted 2 lines
makes it sometimes impossible to access any registers/dram/devices anymore, only zeros can be
read.
Quoted 2 lines
It also freezes the CPU somehow the debugger cannot
halt it
Quoted 1 line
anymore with a normal halt (COP halt), it has to
use COP
Quoted 3 lines
freeze to take over control again.
I cannot say this problem does not occur accessing
other
Quoted 1 line
spaces, so it can also be a problem at the PPC60x
bus.
Quoted 6 lines
Has anyone over excpirianced this before?
Thanks in advance!
Roel
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com