imx8mn-venice-u-boot: Fix broken boot
Subsystems (2)
PATCH 1/1 imx8mn-venice-u-boot: Fix broken boot
When the imx8mm.dtsi file was pulled in from Linux, the UARTs were moved into an spba sub-node which wasn't being included in the SPL device tree. This meant the references to the UART weren't being handled properly and when booting the system would constantly reboot. Fix this by adding the spba node to the spl device tree to restore normal booting.
Based on the patch from Adam Ford for the imx8mn-beacon-kit-u-boot board.
---
Hi Tim,
Could you please test this patch?
It fixes boot regression on imx8mn-evk and imx8mn-beacon.
arch/arm/dts/imx8mn-venice-u-boot.dtsi | 4 ++++ 1 file changed, 4 insertions(+)
arch/arm/dts/imx8mn-venice-u-boot.dtsi +4 -0
@@ -20,6 +20,10 @@ u-boot,dm-spl; }; +&spba1 { + u-boot,dm-spl; +}; + &clk { u-boot,dm-spl; u-boot,dm-pre-reloc;
Signature · 1 line
2.25.1
Hi
Quoted 28 lines · Fabio Estevam
When the
imx8mm.dtsifile was pulled in from Linux, the UARTs were moved into an spba sub-node which wasn't being included in the SPL device tree. This meant the references to the UART weren't being handled properly and when booting the system would constantly reboot. Fix this by adding the spba node to the spl device tree to restore normal booting.Based on the patch from Adam Ford for the imx8mn-beacon-kit-u-boot board.
Fixes 4e5114daf9eb ("imx8mn: synchronise device tree with linux")Signed-off-by Fabio Estevam <[email protected]>---
Hi Tim,Could you please test this patch?
It fixes boot regression on imx8mn-evk and imx8mn-beacon.
arch/arm/dts/imx8mn-venice-u-boot.dtsi | 4 ++++ 1 file changed, 4 insertions(+)arch/arm/dts/imx8mn-venice-u-boot.dtsi +0
-0
arch/arm/dts/imx8mn-venice-u-boot.dtsi line 29
Quoted 10 lines
arch/arm/dts/imx8mn-venice-u-boot.dtsi +4
-0@@ -20,6 +20,10 @@ u-boot,dm-spl; }; +&spba1 { + u-boot,dm-spl; +}; + &clk { u-boot,dm-spl; u-boot,dm-pre-reloc;
I have seen a series already here I think
Quoted 3 lines
--
2.25.1
Signature · 11 lines
Michael Nazzareno Trimarchi Co-Founder & Chief Executive Officer M. +39 347 913 2170 [email protected] __________________________________ Amarula Solutions BV Joop Geesinkweg 125, 1114 AB, Amsterdam, NL T. +31 (0)85 111 9172 [email protected] www.amarulasolutions.com
PATCH 1/1 imx8mn-venice-u-boot: Fix broken boot
In reply to Fabio EstevamQuoted 11 lines
When the
imx8mm.dtsifile was pulled in from Linux, the UARTs were moved into an spba sub-node which wasn't being included in the SPL device tree. This meant the references to the UART weren't being handled properly and when booting the system would constantly reboot. Fix this by adding the spba node to the spl device tree to restore normal booting.
Based on the patch from Adam Ford for the imx8mn-beacon-kit-u-boot board.Fixes 4e5114daf9eb ("imx8mn: synchronise device tree with linux")Signed-off-by Fabio Estevam <[email protected]>Reviewed-by Michael Trimarchi <[email protected]>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] =====================================================================
Fabio Estevam
reviewerHi Stefano,
Quoted 12 lines · On Fri, Oct 21, 2022 at 8:50 AM <[email protected]> wrote:
Quoted 9 lines
When the
imx8mm.dtsifile was pulled in from Linux, the UARTs were moved into an spba sub-node which wasn't being included in the SPL device tree. This meant the references to the UART weren't being handled properly and when booting the system would constantly reboot. Fix this by adding the spba node to the spl device tree to restore normal booting.
Based on the patch from Adam Ford for the imx8mn-beacon-kit-u-boot board.Quoted 3 lines
Fixes 4e5114daf9eb ("imx8mn: synchronise device tree with linux")Signed-off-by Fabio Estevam <[email protected]>Reviewed-by Michael Trimarchi <[email protected]>
Quoted 1 line
Applied to u-boot-imx, master, thanks !
Thanks, but this one is already present in U-Boot 2022.10 final.
Tom applied it directly to avoid the boot regression.
It seems that the u-boot-imx base is not up to date.