Skip to contentSkip to conversation

riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

PATCH Superseded E Shattow 1 participant 2 messages Nov 18, 2024

Subsystems (3)

v3 of 6 Superseded Latest is v6 →

lore
Share & tools
lore

E Shattow

author
#0 lore raw

v3 cover riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

Enable host mode JH7110 on-chip USB for Milk-V Mars by setting host mode and connect vbus pinctrl.

This functionality depends on setting the USB over-current register to disable at bootloader phase, for example U-Boot:
https://patchwork.ozlabs.org/project/uboot/patch/[email protected]/

If the over-current register is not prepared for us then the result is no change in functional outcome with this patch applied; there is an error visible to the user and this additional usb configuration fails (same as it is now). The existing three VL805 connected USB ports via PCIe on Milk-V Mars are not affected.

Changes since v2:
- Rebase on 6.12

Changes since v1:
- series name (was "[PATCH] riscv: dts: starfive: jh7110-milkv-mars: set host mode and vbus pin for on-chip USB 2.0")
- adjust pin label to obey dtschema
- use cover letter

E Shattow (1):
riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

 .../boot/dts/starfive/jh7110-milkv-mars.dts   | 21 +++++++++++++++++++
 1 file changed, 21 insertions(+)
Signature · 1 line
2.45.2
author
#1 lore raw

PATCH v3 1/1 riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

Milk-V Mars set host mode and vbus pin for JH7110 on-chip USB 2.0

---
 .../boot/dts/starfive/jh7110-milkv-mars.dts   | 21 +++++++++++++++++++
 1 file changed, 21 insertions(+)
arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts +21 -0
index 5cb9e99e1dac..45d4f7556521 100644
@@ -35,3 +35,24 @@ &phy0 {
 	rx-internal-delay-ps = <1500>;
 	tx-internal-delay-ps = <1500>;
 };
+
+&sysgpio {
+        usb0_pins: usb0-0 {
+                vbus-pins {
+                        pinmux = <GPIOMUX(25, GPOUT_SYS_USB_DRIVE_VBUS,
+                                              GPOEN_ENABLE,
+                                              GPI_NONE)>;
+                        bias-disable;
+                        input-disable;
+                        input-schmitt-disable;
+                        slew-rate = <0>;
+                };
+        };
+};
+
+&usb0 {
+        dr_mode = "host";
+        pinctrl-names = "default";
+        pinctrl-0 = <&usb0_pins>;
+        status = "okay";
+};
Signature · 1 line
2.45.2