riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function
Subsystems (3)
cover riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function
Enable host mode JH7110 on-chip USB for Pine64 Star64 by setting host mode and connect vbus pinctrl.
This functionality depends on setting the USB over-current register to disable at bootloader phase, for example U-Boot:
https://patchwork.ozlabs.org/project/uboot/patch/[email protected]/
If the over-current register is not prepared for us then the result is no change in functional outcome with this patch applied; there is an error visible to the user and this usb configuration fails (same as it is now).
E Shattow (1):
riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function
.../dts/starfive/jh7110-pine64-star64.dts | 21 +++++++++++++++++++ 1 file changed, 21 insertions(+)
Signature · 1 line
2.45.2
PATCH 1/1 riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function
Pine64 Star64 set host mode and vbus pin for JH7110 on-chip USB 2.0
--- .../dts/starfive/jh7110-pine64-star64.dts | 21 +++++++++++++++++++ 1 file changed, 21 insertions(+)
arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts +21 -0
@@ -62,3 +62,24 @@ &phy1 { motorcomm,tx-clk-10-inverted; motorcomm,tx-clk-100-inverted; }; + +&sysgpio { + usb0_pins: usb0-0 { + vbus-pins { + pinmux = <GPIOMUX(25, GPOUT_SYS_USB_DRIVE_VBUS, + GPOEN_ENABLE, + GPI_NONE)>; + bias-disable; + input-disable; + input-schmitt-disable; + slew-rate = <0>; + }; + }; +}; + +&usb0 { + dr_mode = "host"; + pinctrl-names = "default"; + pinctrl-0 = <&usb0_pins>; + status = "okay"; +};
Signature · 1 line
2.45.2