Skip to contentSkip to conversation

riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function

PATCH Superseded E Shattow 1 participant 2 messages Nov 18, 2024

Subsystems (3)

v1 of 4 Superseded Latest is v4 →

lore
Share & tools
lore

E Shattow

author
#0 lore raw

cover riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function

Enable host mode JH7110 on-chip USB for Pine64 Star64 by setting host mode and connect vbus pinctrl.

This functionality depends on setting the USB over-current register to disable at bootloader phase, for example U-Boot:
https://patchwork.ozlabs.org/project/uboot/patch/[email protected]/

If the over-current register is not prepared for us then the result is no change in functional outcome with this patch applied; there is an error visible to the user and this usb configuration fails (same as it is now).

E Shattow (1):
riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function

 .../dts/starfive/jh7110-pine64-star64.dts     | 21 +++++++++++++++++++
 1 file changed, 21 insertions(+)
Signature · 1 line
2.45.2
author
#1 lore raw

PATCH 1/1 riscv: dts: starfive: jh7110-pine64-star64: enable usb0 host function

Pine64 Star64 set host mode and vbus pin for JH7110 on-chip USB 2.0

---
 .../dts/starfive/jh7110-pine64-star64.dts     | 21 +++++++++++++++++++
 1 file changed, 21 insertions(+)
arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts +21 -0
index 8e39fdc73ecb..9f608d00d3d3 100644
@@ -62,3 +62,24 @@ &phy1 {
 	motorcomm,tx-clk-10-inverted;
 	motorcomm,tx-clk-100-inverted;
 };
+
+&sysgpio {
+        usb0_pins: usb0-0 {
+                vbus-pins {
+                        pinmux = <GPIOMUX(25, GPOUT_SYS_USB_DRIVE_VBUS,
+                                              GPOEN_ENABLE,
+                                              GPI_NONE)>;
+                        bias-disable;
+                        input-disable;
+                        input-schmitt-disable;
+                        slew-rate = <0>;
+                };
+        };
+};
+
+&usb0 {
+        dr_mode = "host";
+        pinctrl-names = "default";
+        pinctrl-0 = <&usb0_pins>;
+        status = "okay";
+};
Signature · 1 line
2.45.2