Skip to contentSkip to conversation

riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

PATCH Superseded E Shattow 1 participant 2 messages Nov 19, 2024

Subsystems (3)

v4 of 6 Superseded Latest is v6 →

lore
Share & tools
lore

E Shattow

author
#0 lore raw

v4 cover riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

Enable host mode JH7110 on-chip USB for Milk-V Mars by setting host mode and connect vbus pinctrl.

This functionality depends on setting the USB over-current register to disable at bootloader phase, for example U-Boot:
https://patchwork.ozlabs.org/project/uboot/patch/[email protected]/

If the over-current register is not prepared for us then the result is no change in functional outcome with this patch applied; there is an error visible to the user and this additional usb configuration fails (same as it is now). The existing three VL805 connected USB ports via PCIe on Milk-V Mars are not affected.

Changes since v3:
- Rebase on linux-next/master
- use tabs for code indent

Changes since v2:
- Rebase on 6.12

Changes since v1:
- series name (was "[PATCH] riscv: dts: starfive: jh7110-milkv-mars: set host mode and vbus pin for on-chip USB 2.0")
- adjust pin label to obey dtschema
- use cover letter

E Shattow (1):
riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

 .../boot/dts/starfive/jh7110-milkv-mars.dts    | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)
Signature · 1 line
2.45.2
author
#1 lore raw

PATCH v4 1/1 riscv: dts: starfive: jh7110-milkv-mars: enable usb0 host function

Milk-V Mars set host mode and vbus pin for JH7110 on-chip USB 2.0

---
 .../boot/dts/starfive/jh7110-milkv-mars.dts    | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)
arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts +17 -1
index 0d248b671d4b..3bd62ab78523 100644
@@ -53,7 +53,23 @@ &spi0 {
 	status = "okay";
 };
 
+&sysgpio {
+	usb0_pins: usb0-0 {
+		vbus-pins {
+			pinmux = <GPIOMUX(25, GPOUT_SYS_USB_DRIVE_VBUS,
+					      GPOEN_ENABLE,
+					      GPI_NONE)>;
+			bias-disable;
+			input-disable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+	};
+};
+
 &usb0 {
-	dr_mode = "peripheral";
+	dr_mode = "host";
+	pinctrl-names = "default";
+	pinctrl-0 = <&usb0_pins>;
 	status = "okay";
 };
Signature · 1 line
2.45.2