Skip to contentSkip to conversation

net: dsa: b53: mmap: Add bcm63268 GPHY power control

PATCH RESEND Applied Kyle Hendry 2 participants 4 messages Aug 14, 2025 – Aug 15, 2025

Subsystems (4)
lore
Share & tools
lore
#0 lore raw

cover net: dsa: b53: mmap: Add bcm63268 GPHY power control

The gpio controller on the bcm63268 has a register for controlling the gigabit phy power. These patches disable low power mode when enabling the gphy port.

This is based on an earlier patch series here:
https://lore.kernel.org/netdev/[email protected]/

I have created a new series since many of the changes were included in the ephy control patches:
https://lore.kernel.org/netdev/[email protected]/

Kyle Hendry (2):
net: dsa: b53: mmap: Add gphy port to phy info for bcm63268
net: dsa: b53: mmap: Implement bcm63268 gphy power control

 drivers/net/dsa/b53/b53_mmap.c | 35 ++++++++++++++++++++++++++++++----
 1 file changed, 31 insertions(+), 4 deletions(-)
Signature · 1 line
2.43.0
#1 lore raw

PATCH RESEND 1/2 net: dsa: b53: mmap: Add gphy port to phy info for bcm63268

Add gphy mask to bcm63xx phy info struct and add data for bcm63268

---
 drivers/net/dsa/b53/b53_mmap.c | 2 ++
 1 file changed, 2 insertions(+)
drivers/net/dsa/b53/b53_mmap.c +2 -0
index f06c3e0cc42a..87e1338765c2 100644
@@ -31,6 +31,7 @@
 #define BCM63XX_EPHY_REG 0x3C
 
 struct b53_phy_info {
+	u32 gphy_port_mask;
 	u32 ephy_enable_mask;
 	u32 ephy_port_mask;
 	u32 ephy_bias_bit;
@@ -65,6 +66,7 @@ static const struct b53_phy_info bcm6368_ephy_info = {
 static const u32 bcm63268_ephy_offsets[] = {4, 9, 14};
 
 static const struct b53_phy_info bcm63268_ephy_info = {
+	.gphy_port_mask = BIT(3),
 	.ephy_enable_mask = GENMASK(4, 0),
 	.ephy_port_mask = GENMASK((ARRAY_SIZE(bcm63268_ephy_offsets) - 1), 0),
 	.ephy_bias_bit = 24,
Signature · 1 line
2.43.0
#2 lore raw

PATCH RESEND 2/2 net: dsa: b53: mmap: Implement bcm63268 gphy power control

In reply to Kyle Hendry

Add check for gphy in enable/disable phy calls and set power bits in gphy control register.

---
 drivers/net/dsa/b53/b53_mmap.c | 33 +++++++++++++++++++++++++++++----
 1 file changed, 29 insertions(+), 4 deletions(-)
drivers/net/dsa/b53/b53_mmap.c +29 -4
index 87e1338765c2..f4a59d8fbdd6 100644
@@ -29,6 +29,10 @@
 #include "b53_priv.h"
 
 #define BCM63XX_EPHY_REG 0x3C
+#define BCM63268_GPHY_REG 0x54
+
+#define GPHY_CTRL_LOW_PWR	BIT(3)
+#define GPHY_CTRL_IDDQ_BIAS	BIT(0)
 
 struct b53_phy_info {
 	u32 gphy_port_mask;
@@ -292,13 +296,30 @@ static int bcm63xx_ephy_set(struct b53_device *dev, int port, bool enable)
 	return regmap_update_bits(gpio_ctrl, BCM63XX_EPHY_REG, mask, val);
 }
 
+static int bcm63268_gphy_set(struct b53_device *dev, bool enable)
+{
+	struct b53_mmap_priv *priv = dev->priv;
+	struct regmap *gpio_ctrl = priv->gpio_ctrl;
+	u32 mask = GPHY_CTRL_IDDQ_BIAS | GPHY_CTRL_LOW_PWR;
+	u32 val = 0;
+
+	if (!enable)
+		val = mask;
+
+	return regmap_update_bits(gpio_ctrl, BCM63268_GPHY_REG, mask, val);
+}
+
 static void b53_mmap_phy_enable(struct b53_device *dev, int port)
 {
 	struct b53_mmap_priv *priv = dev->priv;
 	int ret = 0;
 
-	if (priv->phy_info && (BIT(port) & priv->phy_info->ephy_port_mask))
-		ret = bcm63xx_ephy_set(dev, port, true);
+	if (priv->phy_info) {
+		if (BIT(port) & priv->phy_info->ephy_port_mask)
+			ret = bcm63xx_ephy_set(dev, port, true);
+		else if (BIT(port) & priv->phy_info->gphy_port_mask)
+			ret = bcm63268_gphy_set(dev, true);
+	}
 
 	if (!ret)
 		priv->phys_enabled |= BIT(port);
@@ -309,8 +330,12 @@ static void b53_mmap_phy_disable(struct b53_device *dev, int port)
 	struct b53_mmap_priv *priv = dev->priv;
 	int ret = 0;
 
-	if (priv->phy_info && (BIT(port) & priv->phy_info->ephy_port_mask))
-		ret = bcm63xx_ephy_set(dev, port, false);
+	if (priv->phy_info) {
+		if (BIT(port) & priv->phy_info->ephy_port_mask)
+			ret = bcm63xx_ephy_set(dev, port, false);
+		else if (BIT(port) & priv->phy_info->gphy_port_mask)
+			ret = bcm63268_gphy_set(dev, false);
+	}
 
 	if (!ret)
 		priv->phys_enabled &= ~BIT(port);
Signature · 1 line
2.43.0
#3 lore raw
In reply to Kyle Hendry
This series was applied to netdev/net-next.git (main) by Jakub Kicinski <[email protected]>:

Hello:

This series was applied to netdev/net-next.git (main) by Jakub Kicinski <[email protected]>:

Quoted 8 lines · On Wed, 13 Aug 2025 17:25:26 -0700 you wrote:

The gpio controller on the bcm63268 has a register for controlling the gigabit phy power. These patches disable low power mode when enabling the gphy port.

This is based on an earlier patch series here:
https://lore.kernel.org/netdev/[email protected]/

[...]

Here is the summary with links:
- [RESEND,net-next,1/2] net: dsa: b53: mmap: Add gphy port to phy info for bcm63268

    https://git.kernel.org/netdev/net-next/c/7f95f04fe190
  - [RESEND,net-next,2/2] net: dsa: b53: mmap: Implement bcm63268 gphy power control
    https://git.kernel.org/netdev/net-next/c/61730ac10ba9

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html