Skip to contentSkip to conversation

K9G8G08UM u-boot 1.1.6 saveenv

U-Boot hjj 2 participants 2 messages Nov 2, 2008

lore
Share & tools
lore

hjj

author
#0 lore raw

Hi,every one ,i met a question with u-boot 1.1.6 and nand flash K9G8G08UM?
when i do saveenv, it can save into ram,but when i reset ,it resets the default! following is u-boot information:

U-Boot 1.1.6 (Nov 2 2008 - 10:54:43) for SMDK6400

CPU: S3C6400 at 533MHz

         Fclk = 533MHz, Hclk = 133MHz, Pclk = 66MHz (ASYNC Mode) 
Board:   SMDK6400
DRAM:    128 MB
Flash:   0 kB
NAND:    1024 MB

*** Warning - bad CRC or NAND, using default environment "*** Warning - bad CRC or NAND, using default environment"

this is the main question!

i hope i can get someone help,thanks very much!

#1 lore raw

Dear hjj,

Quoted 6 lines · In message <[email protected]>…

Hi,every one ,i met a question with u-boot 1.1.6 and nand flash K9G8G08UM ??
when i do saveenv, it can save into ram,but when i reset ,it resets the default! following is u-boot information:

U-Boot 1.1.6 (Nov 2 2008 - 10:54:43) for SMDK6400

Don't waste your (and our) time on ancient code. The SMDK6400 is supported in current code. Please make sure to use the latest release (v2008.10) or top of tree from git repository.

Best regards,

Wolfgang Denk

Signature · 4 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Life. Don't talk to me about life.      - Marvin the Paranoid Android