Skip to contentSkip to conversation

wonder shaper problems

LARTC Mark Ryan 2 participants 3 messages Jan 29, 2004 – Jan 30, 2004

lore
Share & tools
lore

Mark Ryan

author
#0 lore raw

I just installed Xandros 2.0 Desktop. I used apt-get to install iproute. I then downloaded wondershaper 1.1a from the website. I edited the script as the readme says.

I went to console and started the wondershaper script...and i get the following error messages.

RTNETLINK answers: Invalid Argument

many times.
Any ideas what is wrong?

MArk

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

Hi Mark

Quoted 7 lines

I went to console and started the wondershaper script...and i get the following error messages.

RTNETLINK answers: Invalid Argument

many times.
Any ideas what is wrong?

Take a look at the archives over the last week or so. This generic question has been raised a few times just recently.

Quoted 1 line

http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

(basically, you're missing kernel modules/config)

Signature · 11 lines
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Damion de Soto - Software Engineer  email:     [email protected]
SnapGear - A CyberGuard Company ---    ph:         +61 7 3435 2809
  | Custom Embedded Solutions          fax:         +61 7 3891 3630
  | and Security Appliances            web: http://www.snapgear.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
  ---  Free Embedded Linux Distro at   http://www.snapgear.org  ---

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
author
#2 lore raw
In reply to Mark Ryan

That is what i was afraid of. I have no idea how to re-compile the QoS modules into the Xandros kernel.

Mark
----- Original Message -----
From: "Damion de Soto" <[email protected]>
To: "Mark Ryan" <[email protected]>
Cc: <[email protected]>
Sent: Thursday, January 29, 2004 6:44 PM
Subject: Re: [LARTC] wonder shaper problems

Quoted 11 lines

Hi Mark

Quoted 7 lines

I went to console and started the wondershaper script...and i get the following error messages.

RTNETLINK answers: Invalid Argument

many times.
Any ideas what is wrong?

Quoted 16 lines

Take a look at the archives over the last week or so. This generic question has been raised a few times just recently.

Quoted 1 line

http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

(basically, you're missing kernel modules/config)

Signature · 7 lines
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Damion de Soto - Software Engineer  email:     [email protected]
SnapGear - A CyberGuard Company ---    ph:         +61 7 3435 2809
  | Custom Embedded Solutions          fax:         +61 7 3891 3630
  | and Security Appliances            web: http://www.snapgear.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
  ---  Free Embedded Linux Distro at   http://www.snapgear.org  ---

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/