Skip to contentSkip to conversation

zynq_z_turn_defconfig: no info from SPL

U-Boot Matwey V. Kornilov 1 participant 2 messages Jul 20, 2019 – Jul 27, 2019

lore
Share & tools
lore
#0 lore raw

Hello,

I am trying to build u-boot v2019.07 with zynq_z_turn_defconfig config. I obtain spl/boot.bin file that is placed at the first FAT partition as required by BootROM docs. I also put u-boot.img and u-boot.bin at the same partition.
However, when I powered the board, nothing happening at all.

I've checked that when I replace boot.bin with a binary provided on the vendor CD disk, the BootROM is able to find and run vendor bootloader.

I even don't see SPL banner when try to rebuild u-boot myself even CONFIG_DEBUG_UART is enabled in the config.

How could I figure out what is happening?

#1 lore raw

20.07.2019 20:20, Matwey V. Kornilov пишет:

Quoted 8 lines

Hello,

I am trying to build u-boot v2019.07 with zynq_z_turn_defconfig config. I obtain spl/boot.bin file that is placed at the first FAT partition as required by BootROM docs. I also put u-boot.img and u-boot.bin at the same partition.
However, when I powered the board, nothing happening at all.

Quoted 7 lines

I've checked that when I replace boot.bin with a binary provided on the vendor CD disk, the BootROM is able to find and run vendor bootloader.

I even don't see SPL banner when try to rebuild u-boot myself even CONFIG_DEBUG_UART is enabled in the config.

How could I figure out what is happening?

This patch helped me https://patchwork.ozlabs.org/patch/1110114/

But I still see only the following:

���渝���
U-Boot SPL 2019.07-00840-g60df776928 (Jul 27 2019 - 18:07:38 +0300) mmc boot
Trying to boot from MMC1

Quoted 6 lines

_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
https://lists.denx.de/listinfo/u-boot