ASoC: max98357a: avoid speaker pop when playback startup
Subsystems (3)
PATCH 1/1 ASoC: max98357a: avoid speaker pop when playback startup
From: Mac Chiang <[email protected]>
Loud speaker pop happens during playback even when in slience playback. Specify Max98357a amp delay times to make sure clocks are always earlier than sdmode on.
Signed-off-by Mac Chiang <[email protected]>
--- .../devicetree/bindings/sound/max98357a.txt | 4 ++ sound/soc/codecs/max98357a.c | 50 ++++++++++++++++++---- 2 files changed, 45 insertions(+), 9 deletions(-)
Documentation/devicetree/bindings/sound/max98357a.txt +4 -0
@@ -9,6 +9,10 @@ Optional properties: - sdmode-gpios : GPIO specifier for the chip's SD_MODE pin. If this option is not specified then driver does not manage the pin state (e.g. chip is always on). +- sdmode-delay : specify delay time for SD_MODE pin. + If this option is specified, which means it's required i2s clocks + ready before SD_MODE is unmuted in order to avoid the speaker pop noise. + It's observed that 5ms is sufficient. Example:
sound/soc/codecs/max98357a.c +41 -9
84 lines not on this page · raw message
Signature · 1 line
2.7.4