Skip to contentSkip to conversation

Bandwith especification.

LARTC Carles Xavier Munyoz Baldó 2 participants 2 messages May 13, 2004

lore
Share & tools
lore
#0 lore raw

Hi,
If I have a DSL router with 300kpbs upload bandwith:
Linux(eth0) ---(100Mbps)---> DSL ---(300kbps)---> INTERNET

Which is the recomended value I must set in my QoS setup for the maximum outbound bandwith of my ethernet interface ?
The max of 300kbps or something less like 290kbps ?

Especify less than the maximum available bandwith is advisable to ensure that the QoS algoritms goes fine, isn't it ?

Greetings.
---
Carles Xavier Munyoz Baldó
[email protected]
http://www.unlimitedmail.net/
---

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 10 lines · Carles Xavier Munyoz Baldó

Hi,
If I have a DSL router with 300kpbs upload bandwith:
Linux(eth0) ---(100Mbps)---> DSL ---(300kbps)---> INTERNET

Which is the recomended value I must set in my QoS setup for the maximum outbound bandwith of my ethernet interface ?
The max of 300kbps or something less like 290kbps ?

Especify less than the maximum available bandwith is advisable to ensure that the QoS algoritms goes fine, isn't it ?

Yes.

Staf

Signature · 6 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/