Can I load uEnv.txt conditionally, based on the boot source?
Hello,
I was wondering if there is a way to tell what the boot source is?
My am335x SOC can boot to the mmc or the flash, based on the status of a digital line. I would like to load the uEnv.txt, only if booting from SD card (mmc). I notice at least in some codebases that the automatic loading of uEnv.txt is based on whether the SD card is available, not whether we are currently booting from the SD card.
Is there a way to sense which we are booting from?
Thanks
Brian
Quoted 6 lines · Brian Smucker
Hello,
I was wondering if there is a way to tell what the boot source is?
My am335x SOC can boot to the mmc or the flash, based on the status of a
digital line. I would like to load the uEnv.txt, only if booting from SD card (mmc). I notice at least in some codebases that the automatic loading of uEnv.txt is based on whether the SD card is available, not whether we are currently booting from the SD card.
Quoted 2 lines
Is there a way to sense which we are booting from?
Are you able to read the same digital line that the SoC is using to decide?
Hello,
That would be the most obvious thing, wouldn't it. I thought of that, but am not sure of the answer in u-boot.
Thanks,
Brian
Quoted 18 lines · Joe Hershberger
Quoted 6 lines · On Tue, Feb 10, 2015 at 7:18 PM, Brian Smucker <[email protected]…
Hello,
I was wondering if there is a way to tell what the boot source is?
My am335x SOC can boot to the mmc or the flash, based on the status
of a digital line. I would like to load the uEnv.txt, only if booting from SD card (mmc). I notice at least in some codebases that the automatic loading of uEnv.txt is based on whether the SD card is available, not whether we are currently booting from the SD card.
Quoted 2 lines
Is there a way to sense which we are booting from?
Are you able to read the same digital line that the SoC is using to decide?
Hi Brian,
Quoted 4 lines · Brian Smucker
Hello,
That would be the most obvious thing, wouldn't it. I thought of that,
but am not sure of the answer in u-boot.
Remember not to top post to the list.
Many devices have a GPIO driver available. Sometimes it's not enabled by the default config. As long as the pin is a GPIO as well as a boot-mode selector it should be easiest to just read the state of the line and load the file or not based on that in a shell script.
Cheers,
-Joe
Quoted 8 lines
Thanks,
BrianOn 2/11/2015 12:09 AM, Joe Hershberger wrote:
On Tue, Feb 10, 2015 at 7:18 PM, Brian Smucker <[email protected]>
Quoted 6 lines · wrote:
Quoted 6 lines
Hello,
I was wondering if there is a way to tell what the boot source is?
My am335x SOC can boot to the mmc or the flash, based on the status of
a digital line. I would like to load the uEnv.txt, only if booting from SD card (mmc). I notice at least in some codebases that the automatic loading of uEnv.txt is based on whether the SD card is available, not whether we are currently booting from the SD card.
Quoted 4 lines
Quoted 2 lines
Is there a way to sense which we are booting from?
Are you able to read the same digital line that the SoC is using to
decide?