pwm: intel: Add PWM driver for a new SoC

Patch 1 adds dt binding document in YAML format. Patch 2 add PWM fan controller driver for LGM SoC.

v15:
- Rebase to latest linux 5.10-rc2

v14:
- Address below review concerns from Uwe Kleine-K�nig.
* Add limitations info about fixed 2-wire mode support.
* Rename clk/reset _disable function names to _release.
* Remove clk & rst from driver data structure. Instead use them as arguments.
* Add pwm_chip.base = -1.
- Resolve missing MODULE_LICENSE warning.

v13:
- Address below review concerns (Philipp Zabel)
* Make unnecessary 2 line comment as 1 line comment.
* Move reset_deassert at the last after clk_enable.
* Remove unnecessary return ret statement from .remove()
- Move platform_set_drvdata() at the top of probe.

v12:
- Rebase to linux 5.9-rc4
- Add Reviewed-by tags from Andy Shevchenko & Rob Herring.

v11:
- Address below review concerns (Andy Shevchenko)
* Fix a issue with dev_err_probe() usage & improve the usage.
* Fix & improve a ordering issue with clk_enable/disable & reset_control assert/deassert.

v10:
- Removed unused of_device.h and added platform_device.h & mod_devicetable.h

v9:
- Address code quality related review concerns (Andy Shevchenko)
- Use devm_add_action_or_reset() instead of explicit unwind calls.

v8:
- Remove fan related optional properties usage, keep them as default. If needed, change pwm-fan driver separately in future to add them as generic properties.

v7:
- Address code quality related review concerns.
- Rename fan related property to pwm-*.
- Fix one make dt_binding_check reported error.

v6:
- Readjust .apply op as per review feedback.
- Add back pwm-cells property to resolve make dt_binding_check error. pwm-cells is a required property for PWM driver.
- Add back fan related optional properties.

v5:
- Address below review concerns from Uwe Kleine-K�nig.
* Improve comments about Limitations.
* Use return value of regmap_update_bits if container function returns error code.
* Modify .apply op to have strict checking for fixed period supported by PWM HW.
* Use u64 as type when use min_t for duty_cycle.
* Add reset_control_assert() in failure case in probe where it was missing earlier.
- Remove fan specific optional properties from pwm dt binding document (Rob Herring)

v4:
- Address below review concerns from Uwe Kleine-K�nig.
* Improve notes and limitations comments.
* Add common prefixes for all #defines.
* Modify/Improve logic in .apply & .get_state ops as advised.
* Skip error messages in probe when error is -EPROBE_DEFER.
* Add dependencies in Kconfig (OF & HAS_IOMEM) and add select REGMAP_MMIO.
* Address other code quality related review concerns.
- Fix make dt_binding_check reported error in YAML file.

v3:
- Address below review concerns from Uwe Kleine-K�nig.
* Remove fan rpm calibration task from the driver.
* Modify apply op as per the review feedback.
* Add roundup & round down where necessary.
* Address other misc code quality related review concerns.
* Use devm_reset_control_get_exclusive(). (Philipp Zabel)
* Improve dt binding document.

v2:
- Address below review concerns from Uwe Kleine-K�nig.
* Add notes and limitations about PWM HW.
* Rename all functions and structure to lgm_pwm_*
* Readjust space aligninment in structure fields to single space.
* Switch to using apply instead of config/enable/disable.
* Address other code quality related concerns.
* Rebase to 5.8-rc1.
- Address review concerns in dt binding YAML from Rob Herring.

v1:
- Initial version.

Rahul Tanwar (2):
Add DT bindings YAML schema for PWM fan controller of LGM SoC Add PWM fan controller driver for LGM SoC

 .../devicetree/bindings/pwm/intel,lgm-pwm.yaml     |  44 ++++
 drivers/pwm/Kconfig                                |  11 +
 drivers/pwm/Makefile                               |   1 +
 drivers/pwm/pwm-intel-lgm.c                        | 244 +++++++++++++++++++++
 4 files changed, 300 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/intel,lgm-pwm.yaml
 create mode 100644 drivers/pwm/pwm-intel-lgm.c

2.11.0

Intel's LGM(Lightning Mountain) SoC contains a PWM fan controller which is only used to control the fan attached to the system. This PWM controller does not have any other consumer other than fan. Add DT bindings documentation for this PWM fan controller.

---
 .../devicetree/bindings/pwm/intel,lgm-pwm.yaml     | 44 ++++++++++++++++++++++
 1 file changed, 44 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/intel,lgm-pwm.yaml

new file mode 100644
index 000000000000..11a606536169
@@ -0,0 +1,44 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/pwm/intel,lgm-pwm.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: LGM SoC PWM fan controller
+
+maintainers:
+  - Rahul Tanwar <[email protected]>
+
+properties:
+  compatible:
+    const: intel,lgm-pwm
+
+  reg:
+    maxItems: 1
+
+  "#pwm-cells":
+    const: 2
+
+  clocks:
+    maxItems: 1
+
+  resets:
+    maxItems: 1
+
+required:
+  - compatible
+  - reg
+  - clocks
+  - resets
+
+additionalProperties: false
+
+examples:
+  - |
+    pwm: pwm@e0d00000 {
+        compatible = "intel,lgm-pwm";
+        reg = <0xe0d00000 0x30>;
+        #pwm-cells = <2>;
+        clocks = <&cgu0 126>;
+        resets = <&rcu0 0x30 21>;
+    };

2.11.0

Intel Lightning Mountain(LGM) SoC contains a PWM fan controller. This PWM controller does not have any other consumer, it is a dedicated PWM controller for fan attached to the system. Add driver for this PWM fan controller.

---
 drivers/pwm/Kconfig         |  11 ++
 drivers/pwm/Makefile        |   1 +
 drivers/pwm/pwm-intel-lgm.c | 244 ++++++++++++++++++++++++++++++++++++++++++++
 3 files changed, 256 insertions(+)
 create mode 100644 drivers/pwm/pwm-intel-lgm.c

index 63be5362fd3a..7218bf3665bc 100644
@@ -232,6 +232,17 @@ config PWM_IMX_TPM
 	  To compile this driver as a module, choose M here: the module
 	  will be called pwm-imx-tpm.
 
+config PWM_INTEL_LGM
+	tristate "Intel LGM PWM support"
+	depends on HAS_IOMEM
+	depends on (OF && X86) || COMPILE_TEST
+	select REGMAP_MMIO
+	help
+	  Generic PWM fan controller driver for LGM SoC.
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called pwm-intel-lgm.
+
 config PWM_IQS620A
 	tristate "Azoteq IQS620A PWM support"
 	depends on MFD_IQS62X || COMPILE_TEST

index cbdcd55d69ee..71beaff894c1 100644
@@ -20,6 +20,7 @@ obj-$(CONFIG_PWM_IMG)		+= pwm-img.o
 obj-$(CONFIG_PWM_IMX1)		+= pwm-imx1.o
 obj-$(CONFIG_PWM_IMX27)		+= pwm-imx27.o
 obj-$(CONFIG_PWM_IMX_TPM)	+= pwm-imx-tpm.o
+obj-$(CONFIG_PWM_INTEL_LGM)	+= pwm-intel-lgm.o
 obj-$(CONFIG_PWM_IQS620A)	+= pwm-iqs620a.o
 obj-$(CONFIG_PWM_JZ4740)	+= pwm-jz4740.o
 obj-$(CONFIG_PWM_LP3943)	+= pwm-lp3943.o

2.11.0

Uwe,

you had concerns about v13 of this. Can you take a look if all your comments have been addressed?

Thanks,
Thierry

Hello,

Best regards
Uwe

Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | https://www.pengutronix.de/ |

Both patches applied, thanks.

Thierry