dt-bindings: arm: qcom: document r0q board binding
PATCH v4 2/2 dt-bindings: arm: qcom: document r0q board binding
Adds compatible for the Samsung Galaxy S22 (SM-S901E) (r0q), which is based on the Snapdragon 8 Gen 1 SoC.
Changes in v3:
- Set r0q to the correct, alphabetical order
Signed-off-by Eric Gonçalves <[email protected]>
--- Documentation/devicetree/bindings/arm/qcom.yaml | 1 + 1 file changed, 1 insertion(+)
Documentation/devicetree/bindings/arm/qcom.yaml +1 -0
@@ -1090,6 +1090,7 @@ properties: - enum: - qcom,sm8450-hdk - qcom,sm8450-qrd + - samsung,r0q - sony,pdx223 - sony,pdx224 - const: qcom,sm8450
Signature · 1 line
2.49.0
PATCH v4 1/2 arm64: dts: qcom: add initial support for Samsung Galaxy S22
Adds new device support for the Samsung Galaxy S22 (SM-S901E) phone
Working features:
- simple-framebuffer
- side buttons
- storage
- usb
Changes in v4:
- Properly format the thread
Changes in v3:
- Removed unnecessary initrd start and end addresses
- Make sure r0q is in right order on Makefile
- Properly format memory addresses
Signed-off-by Eric Gonçalves <[email protected]>
--- arch/arm64/boot/dts/qcom/Makefile | 1 + .../boot/dts/qcom/sm8450-samsung-r0q.dts | 363 ++++++++++++++++++ 2 files changed, 364 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/sm8450-samsung-r0q.dts
arch/arm64/boot/dts/qcom/Makefile +1 -0
@@ -285,6 +285,7 @@ dtb-$(CONFIG_ARCH_QCOM) += sm8350-sony-xperia-sagami-pdx214.dtb dtb-$(CONFIG_ARCH_QCOM) += sm8350-sony-xperia-sagami-pdx215.dtb dtb-$(CONFIG_ARCH_QCOM) += sm8450-hdk.dtb dtb-$(CONFIG_ARCH_QCOM) += sm8450-qrd.dtb +dtb-$(CONFIG_ARCH_QCOM) += sm8450-samsung-r0q.dtb dtb-$(CONFIG_ARCH_QCOM) += sm8450-sony-xperia-nagara-pdx223.dtb dtb-$(CONFIG_ARCH_QCOM) += sm8450-sony-xperia-nagara-pdx224.dtb dtb-$(CONFIG_ARCH_QCOM) += sm8550-hdk.dtb
arch/arm64/boot/dts/qcom/sm8450-samsung-r0q.dts new file +363 -0
363 lines not on this page · raw message
Signature · 1 line
2.49.0